Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Rear external centre door strip - how does it remove ? MFL Model  (Read 1521 times)

0 Members and 1 Guest are viewing this topic.

DrAndyB

  • Senior Member
  • ****
  • Online Online
  • Gender: Male
  • Neston / Cheshire
  • Posts: 993
    • 2.5 V6 CDX Manual (MFL)
    • View Profile

Noticed the front lip of the external black door trim, the one in the rear door has rubbed with the drivers door when opened back door and its lifted the front corner of the strip.   >:(

I had a new strip fitted a few years ago, but I guess you can't get the MFL black ones now ??? (With the chrome strip).

How does the strip come off ?  As gentle heat I think should bend it back, but difficult to get back in with.  I recall somebody mentioning that the whole strip slides a fraction before pulling off ?????

Any advice welcome.

Andy.
Logged

05omegav6

  • Guest

Later ones are secured by a screw at each end and then slide off...

Early ones are also glued in place, which makes succesful removal almost impossible :-\

On the plus side, facelit ones are a direct replacement  :y
Logged

DrAndyB

  • Senior Member
  • ****
  • Online Online
  • Gender: Male
  • Neston / Cheshire
  • Posts: 993
    • 2.5 V6 CDX Manual (MFL)
    • View Profile

No obvious screw from memory at the ends.

Would like.to keep her original.

Guess whole thing is thus stuck on  :'(

Where best to get LF strips then ?  Do these stick on ?

Would need to get them painted correct colour ( velvet or jungle green I believe).
Logged

DrAndyB

  • Senior Member
  • ****
  • Online Online
  • Gender: Male
  • Neston / Cheshire
  • Posts: 993
    • 2.5 V6 CDX Manual (MFL)
    • View Profile

Later ones are secured by a screw at each end and then slide off...

Just to check, this is screw on outside and not inside vai removal of door card ?
Logged

05omegav6

  • Guest

Visible either end with the door open, but earlier ones are also glued...
Logged

Shackeng

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • Ramsbury
  • Posts: 7763
    • 3.2 Elite 2.0 TitX Mondeo
    • View Profile

Noticed the front lip of the external black door trim, the one in the rear door has rubbed with the drivers door when opened back door and its lifted the front corner of the strip.   >:(

I had a new strip fitted a few years ago, but I guess you can't get the MFL black ones now ??? (With the chrome strip).

How does the strip come off ?  As gentle heat I think should bend it back, but difficult to get back in with.  I recall somebody mentioning that the whole strip slides a fraction before pulling off ?????

Any advice welcome.

Andy.

Bought one recently from VX, silly money tho'. :-X
Logged

DrAndyB

  • Senior Member
  • ****
  • Online Online
  • Gender: Male
  • Neston / Cheshire
  • Posts: 993
    • 2.5 V6 CDX Manual (MFL)
    • View Profile

A MFL black one with chrome insert ???

May I ask how much ??
Logged

Shackeng

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • Ramsbury
  • Posts: 7763
    • 3.2 Elite 2.0 TitX Mondeo
    • View Profile

I can't find the invoice but it was £40 - £50 IIRC. I'm pretty sure it wasn't on TC, so ring VX for an up to date price. :y
Logged

TheBoy

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 106929
  • I Like Lockdown
    • Whatever Starts
    • View Profile

No screws on non FL, just stuck.
Logged
Grumpy old man

DrAndyB

  • Senior Member
  • ****
  • Online Online
  • Gender: Male
  • Neston / Cheshire
  • Posts: 993
    • 2.5 V6 CDX Manual (MFL)
    • View Profile

Managed to get one of eBay now.  Brand new vx one  :y
Logged
Pages: [1]   Go Up
 

Page created in 0.023 seconds with 21 queries.