Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Bonnet Release!  (Read 745 times)

0 Members and 1 Guest are viewing this topic.

doughall

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Small village in Wiltshire
  • Posts: 69
  • Here's Tom with the weather!
    • Omega 2.2DTi '02
    • View Profile
Bonnet Release!
« on: 15 May 2007, 14:25:56 »
Is it possible to adjust the bonnet release?
When pulling the lever, it takes someone pushing down on the bonnet to release properly..
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 33990
  • Git!
    • View Profile
Re: Bonnet Release!
« Reply #1 on: 15 May 2007, 14:30:03 »
Yep...remove the small plastic trim cover in front of the battery....here you will see a small clamp with a 10mm bolt on it....slacken the bolt and pull the cable through the clamp until you can just see the bonnet release catch in the slam panel hole move slightly, back it off a touch (for safety) then tighten the clamp....

Also worth winding in the rubber stops on the front corners of the bonnet half a turn....
Logged

doughall

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Small village in Wiltshire
  • Posts: 69
  • Here's Tom with the weather!
    • Omega 2.2DTi '02
    • View Profile
Re: Bonnet Release!
« Reply #2 on: 15 May 2007, 14:45:23 »
Cheers! :-)
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.01 seconds with 17 queries.