I have just received one of those maintenance manuals adverised on EBay.
Anyway, there are also a lot of step by step maintenance guides in the programme with tech drawings to show you what to do. I was going to clean out my throttle body and breathers, when the rain goes away but the first thing the guide said was:
"Throttle Body, Remove and Install (Y 22 XE, Z 22 XE)
Note: When removing and installing or replacing the throttle body it is absolutely essential that the adaptation values for the throttle valve in the EE PROM of the engine control unit are deleted using TECH 2".
What does this mean? If I go ahead with this job will I end up with other problems?
It also says this:
"Note: For engines with throttle valve module (electronic accelerator pedal) it is necessary after replacing the throttle valve module (electronic accelerator pedal) to reprogram it. To do this, switch on the ignition and wait for a minimum period of 10 seconds. During the waiting period, the engine must not be started because this will interrupt the programming operation."
Once again, any ideas??