Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Pages: [1]   Go Down

Author Topic: MV6 Clutch hose clip  (Read 611 times)

0 Members and 1 Guest are viewing this topic.

cwill144

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Oxford
  • Posts: 97
    • 1998 MV6
    • View Profile
MV6 Clutch hose clip
« on: 17 February 2010, 23:51:10 »

After fitting a new engine to my MV6 with manual gearbox I have fitted the clutch flexi hose back into the connector on the bulkhead but when trying to fit the 'U' clip back in I am finding it impossible. The pipe seams to be fully home and I can fit the clip in most of the way but it will not sit fully in any advice? have messed something up with the hose? Itryed a new clip but will not go in.
Logged

Matchless

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Nottingham
  • Posts: 1563
    • A white van
    • View Profile
Re: MV6 Clutch hose clip
« Reply #1 on: 18 February 2010, 10:36:09 »

Access and visibility is poor for that connector.
Try wetting the O rings with a little brake fluid, this might allow the connector to go in a fraction further.
Other possibility is that it is inserted too far, it relies on the O ring being tight in the bore to seal, rather than sealing against the end of the bore so might have been designed with a bit of extra depth.
Logged
Pages: [1]   Go Up
 

Page created in 0.025 seconds with 17 queries.