Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: 1 [2]  All   Go Down

Author Topic: Irmscher twin pipe  (Read 2031 times)

0 Members and 1 Guest are viewing this topic.

Hannah Judes Dad

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Cleethorpes North East Lincs
  • Posts: 1933
    • the misses round the bend
    • View Profile
Re: Irmscher twin pipe
« Reply #15 on: 26 April 2010, 22:18:00 »
Serek's car has a good set up from what I saw at Wollaton Hall so you cant go far wrong with that.
Logged
Don't wee on the electric fence

Dany

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Belgium
  • Posts: 560
    • View Profile
Re: Irmscher twin pipe
« Reply #16 on: 27 April 2010, 00:04:26 »
PM sent Serek, thank you!!
Logged

Pete Elite

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Uxbridge, Middlesex
  • Posts: 1749
    • View Profile
Re: Irmscher twin pipe
« Reply #17 on: 30 April 2010, 23:50:13 »
Where the hanger bar goes through the rubber, try pulling down on the exhaust slightly and push in an old tyre valve or something similar into the hole above or below said bar, this will lower the exhaust slightly and may give you the clearance you require :).

   HTH,
         Pete :y.
Logged
Pages: 1 [2]  All   Go Up
« previous next »
 

Page created in 0.025 seconds with 17 queries.