Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: 1 [2]  All   Go Down

Author Topic: Rear shock replacement - bush bonded on??  (Read 1539 times)

0 Members and 1 Guest are viewing this topic.

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34010
  • Git!
    • View Profile
Re: Rear shock replacement - bush bonded on??
« Reply #15 on: 12 July 2010, 11:40:44 »
But if an owner does not have that cash to spend today, then even a second hand working part is much safer than a failed one.   :y
Logged

Entwood

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • North Wiltshire
  • Posts: 19566
  • My Old 3.2 V6 Elite (LPG)
    • Audi A6 Allroad 3.0 DTI
    • View Profile
Re: Rear shock replacement - bush bonded on??
« Reply #16 on: 12 July 2010, 11:47:31 »
Quote
But if an owner does not have that cash to spend today, then even a second hand working part is much safer than a failed one.   :y

Perhaps .. if the "second hand working" are changed as a pair and both are working correctly ... but just one ... is it "in balance" against the other, if you get my drift ... and this one sounds like it may have been "butchered" off .. which would give me little confidence ... to be honest ... but then I'm a coward .... :(
« Last Edit: 12 July 2010, 11:47:57 by entwood »
Logged

Mark S

  • Newbie
  • *
  • Offline Offline
  • Telford - Shropshire
  • Posts: 23
    • View Profile
Re: Rear shock replacement - bush bonded on??
« Reply #17 on: 12 July 2010, 12:00:44 »
Sure - I take the point. However they were from a low mileage car, so I thought as long as they seemed sound they would be Ok, especially as they don't have any springs etc in them. Looks like one is not that clever anyway, so that won't be much good. I think my next course of action is to contact the guy that sold them to me.
Logged

Dishevelled Den

  • Omega Queen
  • *****
  • Offline Offline
  • Posts: 12545
    • View Profile
Re: Rear shock replacement - bush bonded on??
« Reply #18 on: 12 July 2010, 12:02:55 »
Quote
Quote
But if an owner does not have that cash to spend today, then even a second hand working part is much safer than a failed one.   :y

Perhaps .. if the "second hand working" are changed as a pair and both are working correctly ... but just one ... is it "in balance" against the other, if you get my drift ... and this one sounds like it may have been "butchered" off .. which would give me little confidence ... to be honest ... but then I'm a coward .... :(



Although Mark has a valid point - some people may struggle to raise the money required for new parts - I would walk with you on this one E.  I would never have the confidence to use parts of doubtful provenance. (especially in this critical application)
Logged

Sixstring

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Lydney, Gloucestershire
  • Posts: 2127
  • Its just GOTTA be a big V6. Mmm....NOS........
    • View Profile
Re: Rear shock replacement - bush bonded on??
« Reply #19 on: 12 July 2010, 12:09:22 »
I know i'm an old fart, but my bloke I was apprenticed to ALWAYS told me that anything on an axle from brakes to suspension, to bearings MUST always be changed together on both sides, and s/h parts too must be applied in pairs.
he always reckoned "balance" was affected if only one side done.

Just a comment, dunno if its really the case, but he swore by it.
Logged
Self confessed Electro-Mechanical nut, Guitarist/Singer and Motorcyclist. Drives an estate due to all the equipment he has to carry,Electrickery fiddler who loves Automatics and BIG Vee engines.
Pages: 1 [2]  All   Go Up
« previous next »
 

Page created in 0.024 seconds with 17 queries.