Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: 1 [2]  All   Go Down

Author Topic: max 4,5k rpm and power loss  (Read 2028 times)

0 Members and 1 Guest are viewing this topic.

Welung666

  • Guest
Re: max 4,5k rpm and power loss
« Reply #15 on: 06 October 2010, 18:53:31 »
Quote
ålesund, norway :p

No where near local then ;D ;D ;D

This is for the 2.2 but similar enough for the 2.0 :y

http://www.omegaowners.com/forum/YaBB.pl?num=1269023974
Logged

RGrims

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 7
    • View Profile
Re: max 4,5k rpm and power loss
« Reply #16 on: 06 October 2010, 19:50:43 »
i just noticed that the thin air hose going out on the top left side on the engine was almost torn off, is that bad? :p hehe
Logged

TheBoy

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 107131
  • I Like Lockdown
    • Whatever Starts
    • View Profile
Re: max 4,5k rpm and power loss
« Reply #17 on: 06 October 2010, 19:58:28 »
Quote
i just noticed that the thin air hose going out on the top left side on the engine was almost torn off, is that bad? :p hehe
Fix it whilst you're in a repairing mood :y
Logged
Grumpy old man

RGrims

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 7
    • View Profile
Re: max 4,5k rpm and power loss
« Reply #18 on: 12 October 2010, 17:39:54 »
hi again.
while changing the cam sensor i broke a bolt.. :p
not the one holding the cam sensor but the one below, going inside the engine, so i drilled in it to get the rest of the bolt out but it was stuck so i made a bigger hole so i could fit a new one and accidentally went through, is there something important in there?
i got the same codes btw. 38 and 92
« Last Edit: 12 October 2010, 17:40:15 by RGrims »
Logged

cem_devecioglu

  • Guest
Re: max 4,5k rpm and power loss
« Reply #19 on: 12 October 2010, 19:13:27 »
Quote
hi again.
while changing the cam sensor i broke a bolt.. :p
not the one holding the cam sensor but the one below, going inside the engine, so i drilled in it to get the rest of the bolt out but it was stuck so i made a bigger hole so i could fit a new one and accidentally went through, is there something important in there?
i got the same codes btw. 38 and 92

 :o

any piccie ?
Logged
Pages: 1 [2]  All   Go Up
« previous next »
 

Page created in 0.021 seconds with 17 queries.