Hi Chaps.
The bushes on my Elite are now getting spongy and need replacement.
I just wanted some general advice.....I have had a look at some of the Maintenance guides on the subject which are very informative , but I do have a couple of questions.
First, If I just replace the bushes, is there an orientation that I need to observe and fit the new bushes in same orientation?
Will I need to get the tracking/geometry of the steering re-aligned if I
a) Fit new bushes in existing wishbones
b) Fit new replacement wishbones (with bushes pre-fitted)?
Also if I do fit new bushes to the existing wishbones, will I need a press to push them in or do they push in (as suggested on the Maintenance guide). and I quote "you can now replace the bush with polyurethane as recommended on here as they just press in easily enough get the geometry set up and save a bit of money on tyre wear." As per Razzo's (Steve) nice photos...
I am very keen to do this myself, have tackled new cam belt successfully, new brake discs etc...and do all the other genral maintenance on her - have done for last 10 years of her life.
Finally, where should I purchase bushes/wishbones from?
Many thanks all.
Cheers,
Mel.