Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: EML light ?????  (Read 1352 times)

0 Members and 1 Guest are viewing this topic.

jorton

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Hull
  • Posts: 61
    • View Profile
EML light ?????
« on: 30 January 2008, 16:09:08 »
Hi, ALL.......Replaced the water pump and cleared out the heater matrix. put all back together and started it up and the eml is on constantly......anyone got any dead why ???????....TIA  :y
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34014
  • Git!
    • View Profile
Re: EML light ?????
« Reply #1 on: 30 January 2008, 16:24:37 »
Read the fault codes to get a definative answer.

And make sure everything on the inlet trumpet is plugged back in and that the multiram and air temp sensor connectors have not been muddled up.

Also make sure the EGR is plugged back in and the 1-3-5 bank knock sensor.
Logged

jorton

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Hull
  • Posts: 61
    • View Profile
Re: EML light ?????
« Reply #2 on: 30 January 2008, 16:28:26 »
Cheers mark, one thg i did notice was that the pipe leading from the EGR to the exhaust manifold was a little loose and one of the screw holding the egr to the plenum does tighten up properly, would this causny probs ?
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34014
  • Git!
    • View Profile
Re: EML light ?????
« Reply #3 on: 30 January 2008, 16:43:41 »
The corrugated pipe being loose can cause a ticking noise.

Should be ok on the other joint as its one of 3 bolts.
Logged

Dazzler

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Haverhill, Suffolk
  • Posts: 4198
  • Drive it like you stole it......
    • View Profile
Re: EML light ?????
« Reply #4 on: 30 January 2008, 16:47:55 »
But this would not cause your EML to come on :(
Logged
Big jobbies now finished.....Now running on LPG

jorton

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Hull
  • Posts: 61
    • View Profile
Re: EML light ?????
« Reply #5 on: 30 January 2008, 20:06:51 »
Quote
But this would not cause your EML to come on :(


Found out why the eml light was on.....one of he multi ram wires had popped off, there is a strange rev on it though...when starts to get warm it starts revving by itsself upto about 1900rpm then back to 900 checked all wires anpipes & everything seems ok ?
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34014
  • Git!
    • View Profile
Re: EML light ?????
« Reply #6 on: 30 January 2008, 20:31:22 »
Is the idle valve nice and clean?
Logged

jorton

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Hull
  • Posts: 61
    • View Profile
Re: EML light ?????
« Reply #7 on: 31 January 2008, 20:20:55 »
Quote
Is the idle valve nice and clean?

Its a lot cleaner than it was before took it off, cleaned it out with plenty  carb cleaner then put some 3 in 1 oil in to lube it but been revvin by itself ever since
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.01 seconds with 17 queries.