Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[ScottieMV6]

One of the pipes on the breather system on top of the plenum!!!

Easy to replace or not??

[Marks DTM Calib]

Small one?

[Marks DTM Calib]

Well.....is it the small one?

[ScottieMV6]

Yes if you look from left to right then its number 2.

[Marks DTM Calib]

Ok.....get the broken bit and cut the plastic so the broken section is squared off and roughen up the shaft of the connection slightly.

Now take the breather bridge and again, cut off the fractured piece of plastic so its flush with the main breather body.

You should now have the stump of the breather connection and the breather bridge.

Measure the diameter of the stump (I think its about 6mm but check).

Now open out the hole of the breather bridge where the stump has broken off from to this measured size to a depth of 5-6mm.

Insert the broken off stump into this hole usinga  little glue or better still, sone solvent weld around the shaft of the stump.

Leave to dry and jobs a good un

[ScottieMV6]

Ok.....get the broken bit and cut the plastic so the broken section is squared off and roughen up the shaft of the connection slightly.

Now take the breather bridge and again, cut off the fractured piece of plastic so its lush with the main breather body.

You should now have the stump of the breather connection and the breather bridge.

Measure the diameter of the stump (I think its about 6mm but check).

Now open out the hole of the breather bridge where the stump has broken off from to this measured size to a depth of 5-6mm.

Insert the broken off stump into this hole usinga  little glue or better still, sone solvent weld around the shaft of the stump.

Leave to dry and jobs a good un

Thanks Mark. I'll try that tomorrow.

[Marks DTM Calib]

Had to do the same on one for a member here after somebody in the past had tried to epoxy it back on!