Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please play nicely.  No one wants to listen/read a keyboard warriors rants....

Pages: [1]   Go Down

Author Topic: Advice on Hand Brake cable change  (Read 1217 times)

0 Members and 1 Guest are viewing this topic.

Psychoca

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Female
  • Norfolk
  • Posts: 776
    • Beaten up Mondeo TDCI ST.
    • View Profile
Advice on Hand Brake cable change
« on: 27 January 2009, 13:33:38 »
The handbrake cable snapped on my Miggy today and so I need to change it.

Could anyone give me some guidelines on how is the best and easiest way to swap the old for new as I know it was quite tricky on my old vectra a few years back...

Thank you...
Logged

Elite Pete

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Chester
  • Posts: 19580
  • My spider senses are tingling
    • Audi SQ5 GSX1400
    • View Profile
Re: Advice on Hand Brake cable change
« Reply #1 on: 27 January 2009, 14:07:30 »
I would say give the heatshield nuts a good spray of plusgas in advance, they have a tendency to snap ::)
« Last Edit: 27 January 2009, 14:07:57 by Elite_Pete »
Logged
Retired

ians

  • Omega Baron
  • *****
  • Offline Offline
  • Reading
  • Posts: 3394
    • View Profile
Re: Advice on Hand Brake cable change
« Reply #2 on: 27 January 2009, 21:42:12 »
Its not too bad a job, but aftermarket cable is fine. Vx is v expensive as I recall.
Logged

vauxfan2k

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • Western Isles
  • Posts: 1806
    • View Profile
Re: Advice on Hand Brake cable change
« Reply #3 on: 27 January 2009, 21:50:04 »
Im guessing this had happened on my elite at some point before I bought it, as the heatshields are now held on with self tappers, but removing the heatshields is a MUST.  ;)
Logged

Psychoca

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Female
  • Norfolk
  • Posts: 776
    • Beaten up Mondeo TDCI ST.
    • View Profile
Re: Advice on Hand Brake cable change
« Reply #4 on: 28 January 2009, 07:34:59 »
As I have the tractor, I don't have a haynes manual as there isn't one made for it...  Do I need to drop the exhaust or prop shaft on it???  Stupid question I know...
Logged

Elite Pete

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Chester
  • Posts: 19580
  • My spider senses are tingling
    • Audi SQ5 GSX1400
    • View Profile
Re: Advice on Hand Brake cable change
« Reply #5 on: 28 January 2009, 08:21:25 »
Never done a tractor handbrake, but I wouldn't think so.
Logged
Retired
Pages: [1]   Go Up
« previous next »
 

Page created in 0.022 seconds with 17 queries.