Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to OOF

Pages: [1]   Go Down

Author Topic: running temperature after water pump replacement  (Read 765 times)

0 Members and 1 Guest are viewing this topic.

mark.adams

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Cambridgeshire
  • Posts: 696
  • Happy
    • Omega 2.6 V6 Elite
    • View Profile
running temperature after water pump replacement
« on: 21 August 2010, 10:52:49 »
my Z22XE seems to run a lot hotter after replacing the water pump, dash gauge sits at 90 constantly and fans cut in and out on a normal run, it used to be around 80-85 previously, also the heat from the engine compartment is quite stifling, is this normal?
« Last Edit: 21 August 2010, 13:49:26 by mark.adams »
Logged
Omega 2.6 V6 Elite in Shiny Black

Lizzie_Zoom

  • Guest
Re: running temperature after water pump replacement
« Reply #1 on: 21 August 2010, 14:10:13 »
Quote
my Z22XE seems to run a lot hotter after replacing the water pump, dash gauge sits at 90 constantly and fans cut in and out on a normal run, it used to be around 80-85 previously, also the heat from the engine compartment is quite stifling, is this normal?

Yes, all very normal :y :y
Logged

Andy H

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • Auckland
  • Posts: 5533
    • Mazda MPV
    • View Profile
Re: running temperature after water pump replacement
« Reply #2 on: 21 August 2010, 16:05:09 »
Why did you change the water pump?

If it wasn't circulating water properly the temperature sensor may have been giving an incorrect (low) reading before you changed the pump.
Logged
"Deja Moo - The feeling that you've heard this bull somewhere before."

mark.adams

  • Senior Member
  • ****
  • Offline Offline
  • Gender: Male
  • Cambridgeshire
  • Posts: 696
  • Happy
    • Omega 2.6 V6 Elite
    • View Profile
Re: running temperature after water pump replacement
« Reply #3 on: 21 August 2010, 18:02:11 »
had to as it was pi$$ing water out of it, i didn't change it when i changed cambelt and new cambelt put extra tension on pump shaft
Logged
Omega 2.6 V6 Elite in Shiny Black
Pages: [1]   Go Up
« previous next »
 

Page created in 0.01 seconds with 17 queries.