Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: 1 [2]  All   Go Down

Author Topic: More bits needed - fuel lines, now!  (Read 2073 times)

0 Members and 1 Guest are viewing this topic.

05omegav6

  • Guest
Re: More bits needed - fuel lines, now!
« Reply #15 on: 27 January 2015, 12:08:12 »
Top plate won't leak fuel down the pipe as the pipes run vertically for about an inch from the top plate...

Plate condition can easily be checked by removing the plate in the boot floor :y
Logged

Diamond Black Geezer

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • N E Lincolnshire & Warwickshire
  • Posts: 5712
  • Diamond Black '96 CDX V6 - 'Pissy'
    • & a silly coupe coming...
    • View Profile
Re: More bits needed - fuel lines, now!
« Reply #16 on: 27 January 2015, 13:40:05 »
Quote from: Taxi Al on 27 January 2015, 11:27:22
If it's leaking from the pipe after the filter, just be aware that the leak could well be from the filter connection itself  and running down the pipe :y

Hopefully looking at a low-cost fix then  :)
Logged
Ex-Dealer Kent-Moore Rear Wheel Bearing Tool available for hire, PM for details.

"There's no point in being grown up if you can't be childish sometimes." 4th Doctor

05omegav6

  • Guest
Re: More bits needed - fuel lines, now!
« Reply #17 on: 27 January 2015, 16:28:57 »
Ideally, you'll want that pipe slightly undersized, five minutes in near boiling water will help to fit it over the fuel pipe :y
At the filter end, you'll need a clip either side of the flange to be sure it's secure... but at £4 a meter, it should be a cheap fix :y
Logged
Pages: 1 [2]  All   Go Up
« previous next »
 

Page created in 0.029 seconds with 16 queries.