13. Through Loading Hatch. Ostensibly for the Ski Bag Option and Rear Fridge option.
Remove panel from front of boot, undo and remove reinforcement frame from floor and parcel shelf.
Pop the rear SAM/fuse box out, fit the fridge wiring fuse holder and harness, and pop the rear SAM back.
Run the ground wire to a suitable point.
Fit the new (used) reinforcement frame with the mounting hardware for the hatch and fridge securing points.
Fit the new (used) front panel and hatch, remembering to run the cable out of the receptive.
Inside the car, lift the centre rear seat base and fit the ski bag/through load front attachment hardware and refit the seat base.
An easy hour or so, but actually took about 3 as I included a wiring repair for the Dynamic Seat Pump... It's had a grounding fault recorded since I bought the car and replacing the pump didn't cure it.
Items required:
Through load armrest cubby, (fitted when I put the rear seats in).
Boot panel.
Hatch. These three were used and purchased together, £120.00.
Wiring Harness, New, £20.00.
Hardware, Attachment Hardware, and Screws, New, £15.00.
Reinforcement Frame, used, £80.00.
Factory Option Cost: £240.00.
Total Cost: £235.00.
Saving: £5.00*.
*The factory option includes the ski bag, still available new, ~£380.00

Fridge is an £800.00 option on its own. Have an eye on a couple but they are around £700.00 used
