Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: 1 [2]  All   Go Down

Author Topic: Idle stalling and lack of power generally.  (Read 1843 times)

0 Members and 1 Guest are viewing this topic.

gridx

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Milton Keynes
  • Posts: 16
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #15 on: 24 July 2010, 10:18:10 »
The stalling when driving happens a lot of the time, slightly less when at running temperature. Always under powered. I can make it stall by pushing the throttle up quickly from under the bonnet.

Are you available this morning, I can be there in under an hour?

Thank you for helping out.
Logged

TheBoy

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 106895
  • I Like Lockdown
    • Whatever Starts
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #16 on: 24 July 2010, 10:34:43 »
Quote
The stalling when driving happens a lot of the time, slightly less when at running temperature. Always under powered. I can make it stall by pushing the throttle up quickly from under the bonnet.

Are you available this morning, I can be there in under an hour?

Thank you for helping out.
Sadly, not available this morning, as off to the beer festival shortly.  Not available tomorrow for a related reason ;D
Logged
Grumpy old man

gridx

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Milton Keynes
  • Posts: 16
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #17 on: 24 July 2010, 10:40:31 »
Can I PM you with some contact details?
Logged

gridx

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Milton Keynes
  • Posts: 16
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #18 on: 25 July 2010, 11:32:59 »
I ran the paper clip test. Very simple, even I didn't blow anything up. The only codes were 3x  19 Incorrect RPM Signal. I am not sure if the code is left over from the crank sensor failure 12 months ago so is there any way to clear the codes?

Mel
Logged

Bojan

  • Intermediate Member
  • ***
  • Offline Offline
  • Gender: Male
  • Croatia, Slavonski Brod
  • Posts: 466
    • MV6 3.0
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #19 on: 25 July 2010, 11:52:59 »
Quote
I have noticed it has acquired a high pitched whine on starting that lasts for between 30-60 seconds. This is a new 'feature' along with the irregular idle and stalling.

This could be the SAI pump, located behind the front bumper, on the passanger side (on RHD car).
I have the same sound.
It can be disconected, because it is useless >:(
Logged

gridx

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Milton Keynes
  • Posts: 16
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #20 on: 25 July 2010, 18:07:04 »
When you say disconnect the SAI pump do you mean just pull the electrical connector?

Mel
« Last Edit: 25 July 2010, 18:07:24 by gridx »
Logged

Andy H

  • Omega Lord
  • *****
  • Offline Offline
  • Gender: Male
  • Auckland
  • Posts: 5532
    • Mazda MPV
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #21 on: 25 July 2010, 18:34:05 »
Quote
I ran the paper clip test. Very simple, even I didn't blow anything up. The only codes were 3x  19 Incorrect RPM Signal. I am not sure if the code is left over from the crank sensor failure 12 months ago so is there any way to clear the codes?

Mel
Each code gets repeated 3 times so that sounds right for a failing crank sensor.

I think old codes clear themselves after 25 starts so if you changed the crank sensor a year ago the code should have gone by now.

Did you fit a genuine sensor?
Logged
"Deja Moo - The feeling that you've heard this bull somewhere before."

Bojan

  • Intermediate Member
  • ***
  • Offline Offline
  • Gender: Male
  • Croatia, Slavonski Brod
  • Posts: 466
    • MV6 3.0
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #22 on: 25 July 2010, 21:09:52 »
Quote
When you say disconnect the SAI pump do you mean just pull the electrical connector?

Mel

i think so...i was adviced to pull out the fuse.
I have the same problem, but never got to sort it out.
Logged

gridx

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Milton Keynes
  • Posts: 16
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #23 on: 26 July 2010, 21:55:39 »
Quote
Quote
I ran the paper clip test. Very simple, even I didn't blow anything up. The only codes were 3x  19 Incorrect RPM Signal. I am not sure if the code is left over from the crank sensor failure 12 months ago so is there any way to clear the codes?

Mel
Each code gets repeated 3 times so that sounds right for a failing crank sensor.

I think old codes clear themselves after 25 starts so if you changed the crank sensor a year ago the code should have gone by now.

Did you fit a genuine sensor?

Know idea if it is a Vauxhall part but it is definitely a sensor! Got it from Europarts.

Update - Took out the crank sensor and cleaned the oil off. Think the oil is residual from the rocker cover gaskets leaking. That was fixed about the time it started stalling. The sensor lead had been put over the top of the exhaust so I routed through the large gap by the ABS ECU. Make more sense to me because I can now get to connect easier. I have got pictures if anyone is interested.

Went to work and back without stalling. Still under powered and changing down too often but not as bad as it was. Should I get a new sensor or wait and see if the ECU adjusts to the improvement (I've heard they do that)?

Mel
Logged

Entwood

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • North Wiltshire
  • Posts: 19566
  • My Old 3.2 V6 Elite (LPG)
    • Audi A6 Allroad 3.0 DTI
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #24 on: 26 July 2010, 22:13:52 »
New sensor and VX part ONLY ... buy a pattern one and you'll be changing it again very soon.

Guide in the "how to's" on re-routing the cable.

genuine only .. no messing .. :)
Logged

bertiecbx550

  • Guest
Re: Idle stalling and lack of power generally.
« Reply #25 on: 26 July 2010, 23:35:34 »
Yep don`t i know this  ::) ::) ::)
Logged

gridx

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Milton Keynes
  • Posts: 16
    • View Profile
Re: Idle stalling and lack of power generally.
« Reply #26 on: 27 July 2010, 22:24:08 »
Can anyone recommend a good place to get a crankshaft sensor part 90492061 (oval connector) at a reasonable price?

TIA
Logged
Pages: 1 [2]  All   Go Up
« previous next »
 

Page created in 0.01 seconds with 16 queries.