Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[hoofing it]

cheers omegatoy,

i had missed 2 bolts on the side for starters. its just the last 2 seals that are stuck. i have been using a long bit of wood and tapping on the end with ahammer to try and free it up but i cnt seem to get it very well! gonna give it another try tomorow.

tnx again

Theres a fixing on the bulk head above num 6 that holds the sound proofing on take the plastic retainer off and bend the stud out of the way/snap it off I found it gives you about 1/2" extra clearance.
Watch and not pull num 4 injector wire or as turk says don't trap it.
And if you should drop a bolt (5 or 6)have fun getting it out from behind the starter
Finaly as others say once you have 12 nuts off give it a thump with your fist and it should come free

[Omegatoy]

cheers omegatoy,

i had missed 2 bolts on the side for starters. its just the last 2 seals that are stuck. i have been using a long bit of wood and tapping on the end with ahammer to try and free it up but i cnt seem to get it very well! gonna give it another try tomorow.

tnx again

Theres a fixing on the bulk head above num 6 that holds the sound proofing on take the plastic retainer off and bend the stud out of the way/snap it off I found it gives you about 1/2" extra clearance.
Watch and not pull num 4 injector wire or as turk says don't trap it.
And if you should drop a bolt (5 or 6)have fun getting it out from behind the starter
Finaly as others say once you have 12 nuts off give it a thump with your fist and it should come free

[

lol yeh that job is a right pain!! make sure you dont drop them or have a flexible magnet wand, and even then it may not come out!!