Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega Electrical and Audio Help / Help on Omega Elite V/2000 Audio Installation.

« on: 06 May 2009, 19:39:17 »

I have just bought a new Alpine CDE-W203Ri stereo, which is replacing the CCR-2006 but cannot get the speakers to work. It has the built in BOSS sound system and traffic master but don't know if that would make any diff?
Has anyone got the colour diagrams for the wire loom, if i need to start cutting wires?  :-?

2

Omega General Help / Self Levelling fluid refill?

« on: 10 November 2009, 11:34:21 »

I've managed to get a pair of Self Levelling Shocks, but where do you top the fluid up for them? and has anyone got pictures? it's for a Elite 3l V6 vreg 2000.
Cheers.

3

Omega General Help / Self Levelling Shocks

« on: 04 November 2009, 14:44:01 »

On the back of my Elite it has leaking self levelling shocks, can these be repaired or has anyone on here got any for sale?

4

Omega General Help / Gearbox warning

« on: 04 October 2009, 19:42:20 »

I've got a 3l v6 auto vreg, on my way to work this evening the check automatic gearbox flashed up on the screen. Also the TC light came on the clock display as well, what could this be?

5

Omega General Help / Omega 3l ellite vreg 2000

« on: 05 September 2009, 12:15:46 »

After months of problems and loads of money spent on garage bills, it's still not working properly.
When on a junction in drive the revs will increase it's self and try to move forward, also if you have the heating on cold it will not cut out, but as soon as you turn it to 16 or above it will?
It has got a leak from the o/s manifold, but would that make a difference???
I’ve had both crankshaft sensors changed and the ICV/MAF sensors, is there anything else that I’m missing like the EGR  :question

6

Omega General Help / Manifold?

« on: 09 July 2009, 19:45:10 »

Firstly of all many thanks to all that helped with the cutting out problem, it’s now sorted it was the MAF sensor that was upside down. 
Secondly how hard is it to change the manifold gasket on a 3.0l v6 elite drivers side?
And has anyone got any useful guides/pictures that would help?

7

Omega General Help / Still Cutting Out

« on: 02 July 2009, 13:39:10 »

Just had a new IACV and fitted it, but it still will cut out but not all the time. It's only when I’m at a junction at tick over at between 500 & 600 rpm, As from my other posts I’ve had the gearbox oil and filter changed, as well as the left side crank shaft sensor.
Am I missing anything stupid, has anyone else had this problem and how did get fixed?

8

Omega General Help / Cutting out?

« on: 25 June 2009, 16:55:09 »

Just got my omega 3.0l elite auto vreg 2000 from the Vauxhall garage, which it went in for when hot cuts out then restarts when cold. They have replaced the crankshaft sensor and now when you come to a junction to stop it will cut out. But it will fire first turn and also, I just left it run for around 15 minutes and it would just cut out again but it will start first time again. This is getting an expensive problem as it's costing me every time it goes in, has anyone got any ideas?
Oh and on the paper clip test, there are no faults found and not even on the Vauxhall computer??

9

Omega General Help / Help gearbox problems

« on: 15 June 2009, 18:43:03 »

As from my last post You won’t believe this, got it back from Vauxhall Friday working fine. It's just done the same thing, is there any other sensors that would cause this to cut the engine off?
They dropped the oil and changed the filter, now I driven it all weekend and it was fine.
Any idea’s ?
 

10

Omega General Help / Help Auto box problems

« on: 03 June 2009, 09:51:54 »

Can anyone help??? After about 10 minutes of driving the indash computer comes up with CHECK AUTO GEARBOX then the engine management light comes on and then the engine cuts out. But when you leave it till it cools down it's OK again for another 10ish minutes, it seems to be when it gets to around 80c on the temp dial.

11

Omega General Help / Power Loss

« on: 12 May 2007, 14:18:37 »

Put my Omega elite 3.0 24v v reg, in for the headlights to be reset on the computer at vauxhall.
When i had it back i can only get 110 mph out of it now, What happened to the 156 mph?