Show Posts

1

Omega General Help / power difference

« on: 08 February 2014, 10:36:05 »

what would the power difference be between a 3.0L with 4xg cams chipped ecu to a 2.5 with 4xg cams 3.0l chipped ecu 3.0L lower n upper manifold intake things (cant Remember the name) 3.0l injectors 3.0L exhaust manifolds redtop flywheel 7kgs
is there much difference?

2

General Discussion Area / Mobile friendly

« on: 05 February 2014, 22:19:53 »

I use my phone more then laptop for this forum
the most annoying thing is I cant upload pics by my phone

could this forum be more mobile friendly ?

3

Omega General Help / exhaust help

« on: 05 February 2014, 08:19:40 »

I need help with trying to find a exhaust for my omega but the problem is I cant fit the one form euro carparts cuz of the well the middle box is n sit to low to the floor (if fitted would touch the floor) as my car is low and before some says raise the car up ermm no
I need the closest thing to the genuine centre section were can u get these from

4

General Car Chat / wind deflectors

« on: 04 February 2014, 21:17:59 »

has anyone got any pictures of there omega with team heko wind deflectors ?
plz share

5

Omega General Help / sensor help

« on: 04 February 2014, 19:30:57 »

my omega when code read comes up with engine speed singal wat sensor would that be ?

6

Omega General Help / help with v6 cranks

« on: 02 February 2014, 10:57:09 »

just got my car omega back on the road after but my 3.0l in it and my BOTTOM END went

so would a 2.5l bottom end fit ?
as there roughly the same engine

7

Omega General Help / redtop fly on a x30xe

« on: 14 January 2014, 09:03:12 »

im doing the redtop flywheel conversion n just wanted to make sure that u can use the redtop flywheel bolts on the x30xe ?

8

Omega General Help / gearbox ratios

« on: 07 January 2014, 20:54:12 »

could someone tell me the ratios of the omega gearbox range please

9

Omega General Help / clutch slave cyl spacer

« on: 12 November 2013, 17:52:48 »

Does any have the measuments for the clutch slave cyl spacer when you put the red top flat type flywheel on

10

Omega General Help / ex police omegas

« on: 06 November 2013, 21:25:01 »

i bought A ex police car just wanted to know a few things

some people say that there chipped and have 4 x g cams and played about inlets is this true
and what diff oil should i but in as it has a lsd ?

11

Omega General Help / fly wheel help

« on: 06 November 2013, 21:19:53 »

hi wanna put a lighter fly wheel on my x30xe before in goes in my omega
i have been do some research and found this

flat type flywheel from early c20xe/let 6.4kgs
clutch plate from vectra B v6
pressure plate c20xe/let
need spacer for slave cyl.

but still have some question

one being does the clutch plate from the c20xe/let not fit
and is 6.4kg flywheel the ligthest u can go ?

12

Omega General Help / egr removing help

« on: 13 September 2013, 14:00:58 »

i wanna remove egr completey(ish) form my 3.0l engine i have got
if i was to blank it off on the inlet mainfold n exhaust but leave pluged in will that be ok ?
also the the to pipes that come out of each side on the exhaust manifold remove them n weld the holes up and remove all the pipe work rubish that goes down in the the n/s/f bumper will i have any running problems or any ligths??

13