Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: 1 plug left!

« on: 21 November 2007, 08:09:33 »

Yes, basically I'd messed up, I'd plugged the knock sensor into the connector that is on the plastic tube with the injector connections on it, between 3 & 4 injectors there is a 3 pin socket and I put it on that.

2

Omega General Help / Re: 1 plug left!

« on: 20 November 2007, 18:19:30 »

Right, numpty had it plugged into the wrong thing!

It's all o.k. now, I have the power back and the EML is now off.

I just want to say thanks to all that made suggestions  

3

Omega General Help / Re: 1 plug left!

« on: 20 November 2007, 12:54:39 »

Right it flashed....

1 pause 10 pause 3 pause 2 pause 5

Now After a bit of digging I assume it has the siemens simtec ecu and that means the knock sensor, now I remember plugging that in.......now if I plugged it in the right place is a whole different story!  

Now this would explain the slight hesitancy and the lack of power, I assume it knocks the timing back in a "get you home mode"?

4

Omega General Help / Re: 1 plug left!

« on: 20 November 2007, 12:36:03 »

Will do!

Thanks for all your help.

5

Omega General Help / Re: 1 plug left!

« on: 19 November 2007, 22:59:43 »

Heres a pic, sadly it's a bit dark and it was piddling down!

6

Omega General Help / Re: 1 plug left!

« on: 19 November 2007, 22:03:12 »

Thanks for the suggestions everyone.

I'll take a piccy and post  that up.

Thanks for the help.

7

Omega General Help / 1 plug left!

« on: 19 November 2007, 19:16:30 »

Hi all,

2 weeks ago the head gasket went on my 96 2.0, so over the weekend I took the head off, got it skimmed and put it all back together, all seemed good apart from one electrical plug that I can't remember/find where it plugs into :-?

It is one of the ones that comes out of the back of the plastic casing that goes on top of the injectors, now I have all the ones for the ECU temp sender/EGR/Dash temp and coil all connected but I just have this black 3 pin socket left!

The car runs but she's a little hesitant and the management light is staying on, does anyone have any ideas where it goes?


Many thanks

Paul

8

Newbie Welcome Area / Re: Hello

« on: 20 November 2007, 13:03:56 »

Erm well I enjoyed it but the waterpump and headgasket didn't!

I must admit my car is a bit tired and needs a bit of TLC but it's hard to get time to work on it when I've got shedloads to do on the other car  

9

Newbie Welcome Area / Re: Hello

« on: 19 November 2007, 22:04:21 »

Thanks for the nice reception!  

10

Newbie Welcome Area / Hello

« on: 19 November 2007, 19:05:34 »

Hi all!

Just a quick hello, I have a 96 2.0i Omega and the poor old girl has has a few probs of late (the Nurburgring didn't do it any favours!) so I'll be mooching around the tech sections!

Cheers

Paul