Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

1

Omega General Help / Re: ecotec seal

« on: 21 June 2007, 23:24:51 »

hi could you please post on here when you have managed to find the seal i too need one and was told by vauxhall it came as part of the ecotec unit at a cost of £74 + vat i tried asking autovaux and they never replied
cheers

2

Omega General Help / 1998 pre facelift 2.5v6 cdx pipe locations help

« on: 22 March 2007, 09:48:21 »

i have looked all over the forums and cannot find information on pipe locations even the haynes book dosent help much is there anyone in bradford with a v6 i could look at there vac pipes set up ?or could someone please confirm which pipe goes to the fuel pressure regulator any help please  

3

Omega General Help / Re: omega outside temp sender location

« on: 14 November 2006, 10:39:39 »

no m8 mine has not got climate control just outside temp,radio display and date/time will check connectors to display if sensor is working going to check it on test meter

4

Omega General Help / Re: omega outside temp sender location

« on: 14 November 2006, 10:30:29 »

cheers mate display is saying -33 c but goes down to -28 when driving going to see if its had it or needs cleaning or contacts dirty many thanks m8

5

Omega General Help / omega outside temp sender location

« on: 14 November 2006, 10:24:30 »

hi ive looked all over this forum and cannot find where the sender unit is located for the outside temp display in the car 1995 16v 2.0 gls estate just bought this car and after reading posts in forum checked all breathers, all were blocked, maf sensor was broken, egr valve was bust, idle speed stepper motor dirty. thanks to the paper clip test saved me major headache, i may have to remove head yet to do valve guides as when sat at junction engine on idle then set off blue smoke seems to come out of exhaust. i have worked on vectras before(snapped cam belt at 70mph 14 valves bent) but omegas seem to be easier due to position of engine but for now any help on location of sensor and do vauxhall do a 7 seat conversion kit for boot or any after market ones available?