Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Show Posts

This section allows you to view all posts made by this member. Note that you can only see posts made in areas you currently have access to.

Messages - kefan

Pages: [1]
1
Omega General Help / Question about temp gauge... (Omega B)
« on: 04 February 2011, 21:38:51 »
Hi,
Least the title is unclear, but anyway ... The picture is even worse because it is a bad phone. This is a device that shows the temperature of coolant in Omega B before the facelift. My question is - if someone has played with Tech or other diagnostic equipment, what is the temperature of the first two bars?
The third bar - it is clear - 90 degrees - long ago I had the equipment and testing - that is true now I do, but I wonder how many degrees of water are actually the first two divisions.
Thanks a lot!

2
Omega General Help / Re: Question about Motronic 1.5.4
« on: 29 March 2009, 21:46:52 »
Because I was not sure… So I asked…
But is it possible to work as half-group (inject by pairs) at low and middle engine load, and as a full-group at cold start and full load?
 [smiley=wink.gif] [smiley=wink.gif]

3
Omega General Help / Re: Question about Motronic 1.5.4
« on: 29 March 2009, 20:58:04 »
Quote
Fully sequential PWM

Actually it is not possible to be sequential, because there is no camshaft sensor, so there is no any information about first piston top point.
I checked the signals with oscilloskope (2 channels) and the result is – full-group. All four injectors inject gasoline at the same time!
Ragards!

4
Omega General Help / Re: Question about Motronic 1.5.4
« on: 23 March 2009, 10:07:00 »
Quote
Fully sequential PWM

Thanks! But what does PMW mean?

5
Omega General Help / Question about Motronic 1.5.4
« on: 23 March 2009, 09:45:18 »
 Hi,
I need to know what kind of signals are between ECU and injectors?
Same time (full-group), by pairs (half-group) or independent (sequential)?
The engine is X20SE, 8 valves, 115 hp.
Thanks a lot!

6
Newbie Welcome Area / [ch919][ch953]
« on: 23 March 2009, 09:38:46 »
[ch919][ch953] everybody!
I am glad to join in your forum.

Pages: [1]

Page created in 0.008 seconds with 14 queries.