Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[JamesV6CDX]

The KME and grey injectors do not cause lag on 3.2 Omegas, unlike the high rpm gearchange problems I've never managed to fully overcome on the 3.0 that has red valteks

That's exactly my issue. High RPM gearchange problems...

May just set it to flick to petrol at 5000rpm and forget about it!

[tunnie]

Think my 3.2 has only hit 5k rpm about 4 times since I got it 

Only used the S button once too 

[TheBoy]

Hmmm, mine would spend most of its non-cruising life on petrol

[TheBoy]

Think my 3.2 has only hit 5k rpm about 4 times since I got it 

Only used the S button once too 

Want me to try?

[tunnie]

Think my 3.2 has only hit 5k rpm about 4 times since I got it 

Only used the S button once too 

Want me to try?

Sure, while you have it, fix that relief valve spring 

[TheBoy]

Think my 3.2 has only hit 5k rpm about 4 times since I got it 

Only used the S button once too 

Want me to try?

Sure, while you have it, fix that relief valve spring 

Have you not done that simple task yet

[Lazydocker]

As said, I think we've pinned it down to the injectors. I'm not convinced the Vap was innocent but the KME is well overspecced for the job

Also as said, KME Reducer and AC Rail and  there are no issues right to the red line I can confirm this because I'm back driving the Omega again for a while

[tunnie]

Think my 3.2 has only hit 5k rpm about 4 times since I got it 

Only used the S button once too 

Want me to try?

Sure, while you have it, fix that relief valve spring 

Have you not done that simple task yet

Nothing simple about it 

[sassanach]

what are these "grey" injectors.

[Lazydocker]

what are these "grey" injectors.

3ohm, look like the Valteks but branded AC or Autogaz and seem to work. Mine's on 2.3mm nozzles, 1.1 BAR and perfect to the redline every time

2.5mm and the idle is a bit lumpy

[sassanach]

where are they available from?

[TheBoy]

what are these "grey" injectors.

3ohm, look like the Valteks but branded AC or Autogaz and seem to work. Mine's on 2.3mm nozzles, 1.1 BAR and perfect to the redline every time

2.5mm and the idle is a bit lumpy

No shit, Sherlock.

Teilo has gone awfully quiet again, I'll try to call him tomorrow again.

[Lazydocker]

what are these "grey" injectors.

3ohm, look like the Valteks but branded AC or Autogaz and seem to work. Mine's on 2.3mm nozzles, 1.1 BAR and perfect to the redline every time

2.5mm and the idle is a bit lumpy

No shit, Sherlock.

Teilo has gone awfully quiet again, I'll try to call him tomorrow again.

Apologies to both you and another member... I've not had a chance to call him I'll try tomorrow

[sassanach]

i would like to try these "grey"injectors on the rangie, how much and where?

[TheBoy]

i would like to try these "grey"injectors on the rangie, how much and where?

mine were supplied via a company called Motogas, but Lazydocker has a contact (owner I think) there that does us good deals, although bloody hard to get hold of.  Try dropping Lazydocker a PM