News:

Please check the Forum Guidelines at the top of the Newbie section

Main Menu

Torque wrench question

Started by SMD, 18 December 2012, 10:38:47

Previous topic - Next topic

0 Members and 0 Guests are viewing this topic.

SMD

There is a small hole on the side of my torque wrench which is plugged off with a small cap. What's the purpose for this hole? I seem to be missing both caps after lending out my wrenches. Am I worrying about a non issue?

Entwood

Quote from: SMD on 18 December 2012, 10:38:47
There is a small hole on the side of my torque wrench which is plugged off with a small cap. What's the purpose for this hole? I seem to be missing both caps after lending out my wrenches. Am I worrying about a non issue?

probably .... :)

At a guess its for the insertion of a special tool to adjust the spring tension when the wrench is calibrated

Lazydocker

Quote from: Entwood on 18 December 2012, 10:48:51
Quote from: SMD on 18 December 2012, 10:38:47
There is a small hole on the side of my torque wrench which is plugged off with a small cap. What's the purpose for this hole? I seem to be missing both caps after lending out my wrenches. Am I worrying about a non issue?

probably .... :)

At a guess its for the insertion of a special tool to adjust the spring tension when the wrench is calibrated

That would be my thoughts too :y :y
Whatever it is... I didn't do it

biggriffin

Quote from: SMD on 18 December 2012, 10:38:47
There is a small hole on the side of my torque wrench which is plugged off with a small cap. What's the purpose for this hole? I seem to be missing both caps after lending out my wrenches. Am I worrying about a non issue?
urm lending.only to very trusted people's
Hoof'land storeman.

Webby the Bear

Quote from: Lazydocker on 18 December 2012, 12:18:12
Quote from: Entwood on 18 December 2012, 10:48:51
Quote from: SMD on 18 December 2012, 10:38:47
There is a small hole on the side of my torque wrench which is plugged off with a small cap. What's the purpose for this hole? I seem to be missing both caps after lending out my wrenches. Am I worrying about a non issue?

probably .... :)

At a guess its for the insertion of a special tool to adjust the spring tension when the wrench is calibrated

That would be my thoughts too :y :y

+1
RIP Paul Lovejoy

SMD

Forgot about this. It sounds silly but I thought it was for oiling  :P   Both wrenches were lent in as new condition (only used a few times) and came back scratched (and probably dropped) with the caps missing hence I was a understandably peed. Never again   :(

feeutfo