Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Search the maintenance guides for answers to 99.999% of Omega questions

Pages: [1] 2  All   Go Down

Author Topic: Self levelling shocks.  (Read 3068 times)

0 Members and 1 Guest are viewing this topic.

flymofred

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • nr. Tunbridge Wells (Royal)
  • Posts: 139
    • (53) 2.6 Elite Estate
    • View Profile
Self levelling shocks.
« on: 20 December 2013, 18:56:46 »

Just fitted new genuine Vx shocks. Previous ones emptied the oil out. The car was riding much higher than my mate's one (also a Elite estate) on the bad shocks.  So I hoped replacement, along with a better ride would change the ride height. But  no, it now has pumped itself up to what looks like  max height. I just my daughter + 3 mates out but height remains locked at max heights. What is not doing it's jobk? obviously nothing wrong  with the compressor or springs. The car maintains this height overnight. Help Thanks martinH
Logged

YZ250

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Oxford/Bucks border
  • Posts: 4636
    • Black 3.2 Elite Estate
    • View Profile
Re: Self levelling shocks.
« Reply #1 on: 20 December 2013, 19:25:12 »

Have you tried popping the sensor arm off its little ball on the right hand side of the rear axle. Pop the arm off and lower it right down to see if the shocks will come down. The ride height on my elite estate is 692mm from ground to wheel arch through the wheel centre. Ignition on to test this.
« Last Edit: 20 December 2013, 19:28:39 by YZ250 »
Logged
My fun car is a 2020 Bmw F32 430d M Sport with indicators.
My cruiser is an Audi A6 Avant S Line Black Edition with indicators.

biggriffin

  • Omega Lord
  • *****
  • Offline Offline
  • huntingdon, Hoof'land
  • Posts: 9845
    • It's Insignificant
    • View Profile
Re: Self levelling shocks.
« Reply #2 on: 20 December 2013, 19:26:53 »

Look under neath rear of car, drivers side bout half way along the wishbone you will see the height control valve, pop the arm off,  set it to the middle,the car should now sit level,reconnect the arm,.

do it with front wheels chocked and ign on not running.
Logged
Hoof'land storeman.

flymofred

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • nr. Tunbridge Wells (Royal)
  • Posts: 139
    • (53) 2.6 Elite Estate
    • View Profile
Re: Self levelling shocks.
« Reply #3 on: 20 December 2013, 20:16:19 »

Thanks for your replies  I will give it go in the morning (when it's raining) Thanks again.
Logged

tidla

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • solihull
  • Posts: 4097
    • View Profile
Re: Self levelling shocks.
« Reply #4 on: 20 December 2013, 21:57:26 »

Also when moving the arm, dont be impatient as there is a delay before the pump starts or depressurizes.
Logged

chrisgixer

  • Guest
Re: Self levelling shocks.
« Reply #5 on: 20 December 2013, 22:11:12 »

either the pump is not releasing air, or the sensor is reading the height incorrectly.

There is a guide with pics for the sensor arm as the guys have described.

If moving the sensor doesn't drop the car, then you can let the air out if the shocks by pulling the connector off the shock body above the road wheel in the wheel arch. Support the car though or the car could trap your arm as the air releases, although the drop is quite slow.
You can remove the relay in the glove box to control the system like a switch in the mean time, if you like, to get by until it's diagnosed.

You do need to get the ride height down, if the suspension is fully extended/topped out there will be no suspension travel worth the name and you could potentially loose the rear of the car in a bend or similar.
Logged

flymofred

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • nr. Tunbridge Wells (Royal)
  • Posts: 139
    • (53) 2.6 Elite Estate
    • View Profile
Re: Self levelling shocks.
« Reply #6 on: 21 December 2013, 11:53:17 »

Just measured height through wheel cntr 755mm  :(. This arm that needs unclipping front or rear of swingi farm. Oh and p.......g with rain, Hurrah.
Logged

tidla

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • solihull
  • Posts: 4097
    • View Profile
Re: Self levelling shocks.
« Reply #7 on: 21 December 2013, 12:01:30 »

Drivers side of the rear diff.
Logged

flymofred

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • nr. Tunbridge Wells (Royal)
  • Posts: 139
    • (53) 2.6 Elite Estate
    • View Profile
Re: Self levelling shocks.
« Reply #8 on: 21 December 2013, 12:20:16 »

Okay wet and grumpy I love lying in the gutter in the rain (friday night @ Wetherspoons  ::) )I've knocked the link off the trailing arm, pushed it up comp. ran continuously, pushed down , comp. stopped, stood about, bounced on the tow ball no change quessing a couple of minutes should be enough to see a result.? Better try the relay/pipe off next.  Looking @ the fuse layout fuse 27 supplies level + accessory socket is that the same as pulling the relay which I'm not sure is the right one.
« Last Edit: 21 December 2013, 12:30:18 by flymofred »
Logged

amba

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Medway towns
  • Posts: 4827
    • German V6
    • View Profile
Re: Self levelling shocks.
« Reply #9 on: 21 December 2013, 12:56:03 »

To allow shocks to fully deflate its easier to just pull the air lines of each shock,but ensure you have adequate clearance to get arm out as shock will then bottom out.

I had similar fuss when my air shocks were changed couple of years ago and remember messing about releasing air as they wouldnt find a level.Mine turned out to be the pump not relesing air so in effect they were just getting pumped higher on each attempt.
Logged

flymofred

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • nr. Tunbridge Wells (Royal)
  • Posts: 139
    • (53) 2.6 Elite Estate
    • View Profile
Re: Self levelling shocks.
« Reply #10 on: 21 December 2013, 17:26:11 »

Just read in the owners hand book that the self levelling should only begin to work, in an estate, when you have the equivalent of 5 adults in the car. So de-pressuring the shocks and pulling the fuse should solve it. Until I can get the pump checked. I don't see  any caravanning happening for some weeks yet We are up to 775mm now
Logged

amba

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Medway towns
  • Posts: 4827
    • German V6
    • View Profile
Re: Self levelling shocks.
« Reply #11 on: 21 December 2013, 19:32:41 »

Pull the air lines and let them deflate as with that height car would be very unstable to drive and would have little or no dampening
Logged

flymofred

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • nr. Tunbridge Wells (Royal)
  • Posts: 139
    • (53) 2.6 Elite Estate
    • View Profile
Re: Self levelling shocks.
« Reply #12 on: 22 December 2013, 17:51:10 »

Pulled fuse 27 , and removed air pipe from drivers side shock (trolley jack in place) whooosh did the nearside but it seems one does both as no air escaped from the nearside. I refitted the pipes. Anyway as predicted the ride is lower and more compliant. Back to the garage tmrw. Thanks 
Logged

Andy B

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • Bury Lancs
  • Posts: 39778
    • ML350 TDM SmartRoadster
    • View Profile
Re: Self levelling shocks.
« Reply #13 on: 22 December 2013, 17:53:14 »

...but it seems one does both as no air escaped from the nearside.  .....

One pipe goes from the pump/compressor up front to a T piece & then to each side  ;)
Logged

amba

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Medway towns
  • Posts: 4827
    • German V6
    • View Profile
Re: Self levelling shocks.
« Reply #14 on: 22 December 2013, 18:42:45 »

Once you open the sealed system all air should escape
With fuse removed compressor now cannot run so car should behave and handle much better albeit you won't now have any self levelling so ride height should be normal
Need to investigate further but I suspect pump is not releasing pressure hence just pushing more air into an already inflated system
Best of luck with it
Logged
Pages: [1] 2  All   Go Up
 

Page created in 0.011 seconds with 16 queries.