Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[flyer 0712]

I want to fit headlight washers to my 2.2cd...I have all of the bits required......On here sometime ago a member on here put a diagram of the measurements on where to fit the washers on the front bumper and how to cut out the mounting holes for them...I have looked everywhere on here to find that article but with no luck....does anyone know the information that i am looking for please...I would be most gratefull...thanks 

[powerslinky]

I want to fit headlight washers to my 2.2cd...I have all of the bits required......On here sometime ago a member on here put a diagram of the measurements on where to fit the washers on the front bumper and how to cut out the mounting holes for them...I have looked everywhere on here to find that article but with no luck....does anyone know the information that i am looking for please...I would be most gratefull...thanks 

I remember that  . .  . but I can't find it  on "search" either     

 Rob G comes to mind as the poster . .but not 100% on that

PM him  . . . sure he'll help if he can    if he ain't got a picture of it  . .  he'll make one 

[minifreek]

Dunno if this will help or not, but, on the Vectra B bumpers there are marks moulded into the front bumpers (on the inside of the top of the bumper) for mounting washer jets, might be the same on the Omega bumpers...?

[RobG]

[05omegav6]

Dunno if this will help or not, but, on the Vectra B bumpers there are marks moulded into the front bumpers (on the inside of the top of the bumper) for mounting washer jets, might be the same on the Omega bumpers...?

Irmscher and MV6 bumpers both marked in this way

Bumper off and turn it over, it will be obvious

[flyer 0712]

thank you all and Rob G....for all of that information....very obliged to you all.