Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: O2 sensor codes and lumpy running  (Read 840 times)

0 Members and 1 Guest are viewing this topic.

GastronomicKleptomaniac

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • Teesside (the nice bit)
  • Posts: 4015
    • 3.2 plod, 2.6 MV6, etc
    • View Profile
O2 sensor codes and lumpy running
« on: 16 October 2015, 18:07:52 »
Typically the MV6 has decided to repay me for all the tinkering, by throwing a pair of codes, 0130 and 0150. And then idles very roughly, until turned off and turned on again.

Haven't had chance to look yet, obviously going to look for any damaged wiring as a first port of call. Anything else I should be looking for, or is it more likely time for a new pair of sensors?

I haven't dared look at prices yet...
Logged
Servicing and repairs done in NE. Special rates for OOFers! PM me.

C20det

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Belfast
  • Posts: 92
    • 02 3.2 v6 Special
    • View Profile
Re: O2 sensor codes and lumpy running
« Reply #1 on: 22 October 2015, 00:09:32 »
I'm getting an 02 sensor code aswell & struggling to get to the bottom off it , but I would recommend changing them first but stick with the Bosch ones  :y
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.022 seconds with 17 queries.