Project anyone?

[annihilator]

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F163137160339
Needs a bit of work or just buy it and bask in the knowledge you own an "Interceptor" 

[henryd]

https://rover.ebay.com/rover/0/0/0?mpre=https%3A%2F%2Fwww.ebay.co.uk%2Fulk%2Fitm%2F163137160339
Needs a bit of work or just buy it and bask in the knowledge you own an "Interceptor" 

Needs more than a bit of work though

[Sir Tigger KC]

We havn't had a project for a while. 

[henryd]

We havn't had a project for a while. 

Any good with wood,if the tinwork is in that state God knows how the Ash underneath has stood up 

[ronnyd]

We havn't had a project for a while. 

Any good with wood,if the tinwork is in that state God knows how the Ash underneath has stood up 

Needs to be a mechanic AND a chippie.

[Doctor Gollum]

We havn't had a project for a while. 

Any good with wood,if the tinwork is in that state God knows how the Ash underneath has stood up 

Taken root probably 

[aaronjb]

I did a tour of the factory a couple of years back (a PistonHeads Sunday Service) - fascinating place, and the passenger ride in the Plus 8 was quite exciting (might have had something to do with the leggy lady who was doing the driving, though )

[Sir Tigger KC]

1967 Jaguar E-Type 

Might need a polish!   

[aaronjb]

That'll buff right out..

[dave the builder]

Rusty scrap is £125 ton
think someone needs to put the decimal point in the right place 

[annihilator]

"ringing kit" perhaps 

[Doctor Gollum]

"ringing kit" perhaps 

The detailed restoration pictures would be a bit Blue Peter... "Here's one I made earlier..."

[Sir Tigger KC]

I've not seen one of these before, but I like it!  Properly restored it'd high up the cool wall! 

[Nick W]

I've not seen one of these before, but I like it!  Properly restored it'd high up the cool wall! 

I've just the bits to do that: 3.0l V6 with manual gearbox, Triumph front suspension, Capri axle and some 16" steel wheels. Add some 25x75 box section and a weekend's work and it will be a roller

[Sir Tigger KC]

I've not seen one of these before, but I like it!  Properly restored it'd high up the cool wall! 

I've just the bits to do that: 3.0l V6 with manual gearbox, Triumph front suspension, Capri axle and some 16" steel wheels. Add some 25x75 box section and a weekend's work and it will be a roller