What grease did you use?
Did you find any difference after changing the front bush from Powerflex to Strongflex?
What improvement did it have on steering and handling with just the front poly bushed changed and rear left standard?
What improvement did it have on steering and handling with both the front and rear poly bushed poly bushed?
Thanks
I used the grease that came with Strongflex bushes. I used it plenty to all surfaces where metal to bush contacted.
I found some improvement how steering and handling felt when replaced front bush from Powerflex to Strongflex because different in stiffness. It felt a bit more steady to drive overall.
But I must say that Strongflex was better design. There was grid groove where centre metal tube is inserted. This helps greasing it better. At Powerflex there was nothing, only flat surface that wont hold any grease on it when you push that centre tube in place.
I had pretty new rubber bushings before I fitted polys, so I think there was not so much noticeable difference that I wished for. Maybe when cornering difference between rubber and polys could be noticed most. And of course in time, when rubber loosen up polys show why they are better.
Same thing with rear bushing. I did not even wanted any improvement for steering and handling when I changed rear bushing, all I wanted was not to worry about rubber bushes to wear out.