Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[raywilb]

when i open my bonnet (2.2dti ) there is a loose wire which should be attached to the air temperature sensor. i cannot find the air sensor. so need some help in finding it.  p.s sorry to James i think it was who remarked about the wire at the recent Brackley meet whom suggested it was supposed to be attached to aforesaid sensor. at the time i didn,t think it was

[dave the builder]

it's on ebay   

clicky £5 delivered

it should be clipped to the center of the front bumper ,but you have replaced your bumper IIRC 

unless you have the old bumper with it on , or the new bumper has one fitted but not connected 

[raywilb]

it's on ebay   

clicky £5 delivered

it should be clipped to the center of the front bumper ,but you have replaced your bumper IIRC 

unless you have the old bumper with it on , or the new bumper has one fitted but not connected 

its the original bumper . but did have it off , will look tomorrow 

[TheBoy]

So presumably your outside temp reading is reading F (for fault).  That'll confuddle the climate

[STEMO]

When wifey's astra h went in for a front end repair, it came back with the temperature reading around 50° after warm up. Sensor was obviously in close proximity to the hot bits. 

[raywilb]

So presumably your outside temp reading is reading F (for fault).  That'll confuddle the climate

constantly at zero. not too bothered, but if i can find where it is supposed to locate to then it may as well go on

[Andy B]

So presumably your outside temp reading is reading F (for fault).  That'll confuddle the climate

constantly at zero. not too bothered, but if i can find where it is supposed to locate to then it may as well go on

But your inside cabin temp will be up the pole ....

[TheBoy]

PFL - Clips into hole on underside of front bumper, right on the passenger (RHD) corner
FL - Clips into hole on underside of front bumper, near the centre
FL with Irmscher bumper - Clips into hole visible through mess under numberplate.

[dave the builder]

PFL - Clips into hole on underside of front bumper, right on the passenger (RHD) corner
FL - Clips into hole on underside of front bumper, near the centre
FL with Irmscher bumper - Clips into hole visible through mess under numberplate.

Tidy the mess up , it will be even more visible through the mesh