Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: 2.2 16V Z22XE catalytic converter & 'Type Approval'  (Read 1599 times)

0 Members and 2 Guests are viewing this topic.

Enceladus

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • London
  • Posts: 1105
    • View Profile
2.2 16V Z22XE catalytic converter & 'Type Approval'
« on: 07 August 2019, 01:27:33 »
Having had a closer look at the exhaust problem mentioned here, it seems that the flexible pipe section in front of the downstream cat is blowing at one end. See photo below. The outer weave is torn on the right edge, upstream side of the main cat. The main cat itself seems to be working as there is no EML

Is there a way to repair the flexible section or do I need a whole new 'Type Apptoved' down-pipe with cats?
Did the factory Z22XE downpipe have a flexible section or is this an aftermarket?

Thanks,



Logged

Doctor Gollum

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • In a colds and darks puddleses
  • Posts: 30027
  • If you can't eat them, join them...
    • Feetses.
    • View Profile
Re: 2.2 16V Z22XE catalytic converter & 'Type Approval'
« Reply #1 on: 07 August 2019, 02:13:33 »
It's factory  ;)

You can get repair flexis, but fitting in situ is a pita, so may just as well fit new, but that's your choice  :y
Logged
Onanists always think outside the box.

Enceladus

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • London
  • Posts: 1105
    • View Profile
Re: 2.2 16V Z22XE catalytic converter & 'Type Approval'
« Reply #2 on: 08 August 2019, 05:45:42 »
It's also rusted through at the flanges that join to the middle section. The back box is also 7 years old and not original. So looks like I'm in for a whole new exhaust.

What's the best assembly paste and/or sealer to use these days?
Logged

Enceladus

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • London
  • Posts: 1105
    • View Profile
Re: 2.2 16V Z22XE catalytic converter & 'Type Approval'
« Reply #3 on: 12 August 2019, 00:40:35 »
X22XE 2.2 16V. How is the cat downpipe attached to the manifold?
M8 hex head bolts with copper nuts?
Or is it studs with copper nuts?

What size are the bolts? Or studs?
And can they be replaced with stainless?

M8 copper nuts are listed on EPC and I have some.
But there's no mention of bolts or studs?


Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.017 seconds with 17 queries.