Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: 1 2 3 4 5 6 [7]   Go Down

Author Topic: ABS-light constantly on after replacing front ABS/wheel speed sensors  (Read 34192 times)

0 Members and 3 Guests are viewing this topic.

Enceladus

  • Omega Knight
  • *****
  • Offline Offline
  • Gender: Male
  • London
  • Posts: 1107
    • View Profile
Re: ABS-light constantly on after replacing front ABS/wheel speed sensors
« Reply #90 on: 30 October 2023, 15:50:25 »
Not to mention that the signal from the Carlton seems to be less noisy than the OP is getting.
« Last Edit: 30 October 2023, 16:05:23 by Enceladus »
Logged

LC0112G

  • Omega Baron
  • *****
  • Offline Offline
  • 0
  • Posts: 2618
    • View Profile
Re: ABS-light constantly on after replacing front ABS/wheel speed sensors
« Reply #91 on: 30 October 2023, 17:13:22 »
Quote from: STEMO on 30 October 2023, 14:56:42
Once you get the bit between your teeth, Malcolm......... ;D ;D

The question occasionally crops up in 'another place', and now I've got something to beat the non-believers over the head with ;D
Logged

bkorven

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Sweden
  • Posts: 39
    • '98 Omega B 2.0 16V
    • View Profile
Re: ABS-light constantly on after replacing front ABS/wheel speed sensors
« Reply #92 on: 31 October 2023, 14:08:00 »
Thank you for your input and measurements, LC0112G!

It's so nice to have a benchmark, and to have ones suspicions confirmed. Your signal is significantly stronger.
Logged

bkorven

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • Sweden
  • Posts: 39
    • '98 Omega B 2.0 16V
    • View Profile
Re: ABS-light constantly on after replacing front ABS/wheel speed sensors
« Reply #93 on: 08 November 2023, 23:33:13 »
This will be the final update, an end to it all.

The steering knuckles arrived, and were installed tonight. Look below for the result!







1.220 V @ 76 Hz (~1.6 revolutions / sec). For comparisson, I previously managed to get about 30mV at that speed with the other sensors.

I'm a bit surprised, the voltage is even higher than I was hoping for. Regardless, the signal is super clean and the ABS is working flawlessly. Case closed. FINALLY!

Conclusion: Avoid shady beer-named brands for sensors. And do not expect to be able to remove ABS-sensors.

Thank you all for helping me out!
Logged
Pages: 1 2 3 4 5 6 [7]   Go Up
« previous next »
 

Page created in 0.01 seconds with 17 queries.