Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: V6 oil level sensor  (Read 1843 times)

0 Members and 1 Guest are viewing this topic.

Stu.C

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Lancashire
  • Posts: 129
    • 2.0 Capri / 3.0 Elite-ish
    • View Profile
    • Visit the blog...
V6 oil level sensor
« on: 09 September 2025, 21:54:55 »
Is there a trick to getting the connector out of the sump? The Haynes says to remove the clip and "simply" push the connector through from the outside. I suspect that the thing's just gone a bit brittle after nearly thirty years and doesn't want to budge, but I thought I'd check first rather than go heavy on it.  :y





The bit of the connector on the inside of the sump is all one piece, right? Before I go trying to undo it or anything ...


Logged
Nothing better to do ? Visit the blog at cuyahoga.co.uk

Doctor Gollum

  • Get A Life!!
  • *****
  • Offline Offline
  • Gender: Male
  • In a colds and darks puddleses
  • Posts: 30180
  • If you can't eat them, join them...
    • Feetses.
    • View Profile
Re: V6 oil level sensor
« Reply #1 on: 09 September 2025, 23:36:30 »
It might require some gentle persuasion, but should simply push onto the sump once the clip is removed.

The seal.is probably oil soaked and baked plastic now, so expect to replace it even if the sensor itself is fine.
Logged
Onanists always think outside the box.

Stu.C

  • Junior Member
  • **
  • Offline Offline
  • Gender: Male
  • Lancashire
  • Posts: 129
    • 2.0 Capri / 3.0 Elite-ish
    • View Profile
    • Visit the blog...
Re: V6 oil level sensor
« Reply #2 on: 10 September 2025, 11:58:43 »
 :y  Thanks for the confirmation Doc
Logged
Nothing better to do ? Visit the blog at cuyahoga.co.uk
Pages: [1]   Go Up
« previous next »
 

Page created in 0.42 seconds with 20 queries.