Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Head Gasket - knackered before fitting?  (Read 1078 times)

0 Members and 1 Guest are viewing this topic.

JamesV6CDX

  • Omega Queen
  • *****
  • Offline Offline
  • Gloucestershire/Buckinghamshire
  • Posts: 16640
    • Omega 3.2 Retail MV6 LPG
    • View Profile
Head Gasket - knackered before fitting?
« on: 25 March 2007, 10:34:32 »
last night I inspected my V6 gasket kit....and put the head gaskets side by side.

There is a soft red seal that goes all around the edge of the gasket... but...

On one gasket, it runs true all along the top long straight of the gasket... however on the other gasket, it stats a few mm from the edge of the gasket at one end... and finishes up right by the edge of the gasket when it reaches the other end.. the line is not straight..

What does this red seal do on the HG...just an airtight seal? (If so, I might get away with it) and is this likely to cause me an issue?



« Last Edit: 25 March 2007, 10:35:38 by JamesV6CDX »
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34016
  • Git!
    • View Profile
Re: Head Gasket - knackered before fitting?
« Reply #1 on: 25 March 2007, 11:54:10 »
Its an additional water seal......no big deal as long as its tehre and continuous...

What make are the gaskets....Elring?
Logged

JamesV6CDX

  • Omega Queen
  • *****
  • Offline Offline
  • Gloucestershire/Buckinghamshire
  • Posts: 16640
    • Omega 3.2 Retail MV6 LPG
    • View Profile
Re: Head Gasket - knackered before fitting?
« Reply #2 on: 25 March 2007, 11:56:06 »
Quote
Its an additional water seal......no big deal as long as its tehre and continuous...

What make are the gaskets....Elring?

Yep, it's there and continuous....

The gasket set is FAI....
Logged

Marks DTM Calib

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • West Bridgford
  • Posts: 34016
  • Git!
    • View Profile
Re: Head Gasket - knackered before fitting?
« Reply #3 on: 25 March 2007, 11:57:06 »
Should be fine then...
Logged

JamesV6CDX

  • Omega Queen
  • *****
  • Offline Offline
  • Gloucestershire/Buckinghamshire
  • Posts: 16640
    • Omega 3.2 Retail MV6 LPG
    • View Profile
Re: Head Gasket - knackered before fitting?
« Reply #4 on: 25 March 2007, 12:01:49 »
Quote
Should be fine then...

Cool, I will take a pic later and post it up....
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.013 seconds with 17 queries.