Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[iangts]

Hi just recently picked up a 2.0 Omega L reg, Great Car !

Two problems i was wondering if anyone could help with ?  

First - I think the idle air control valve is gone. Have tried cleaning it but works for a little while then revs go crazy when i stop etc... Where is the best place to get one ?

Second - The heaters are not working properley. I have drained the systems twice and flushed it etc... Top pipe is hot but bottom pipe is warm where it goes into matrix ? inside car.
 The air is not cold it is slighlty warm, Just wondering if their is an easy fix. its not the head gasket etc... as i've checked all that.

Any help would be great !.

P.s also what are these cars like for towing a car on a trailer ?

Thanks.

Ian.

[Auto Addict]

Welcome to the forum

Have you followed the guides on here in the 'Maintenance' section for cleaning out the idle control valve?

Have you cleaned out the throttle body and breathers?

Have you replaced all the gaskets with new if and when you did it?

Can't help with heater.

[Marks DTM Calib]

Yes, it is ESSENTIAL that the throttle body AND breathers are cleaned out when doing the idle valve, if you dont it will be good for a short period until another bit of crudd gets dislodged from the breathers and cloggs the idle valve again.

[iangts]

Hi thanks for the replys  

i've tried clenaing it out and all the pipes etc and replaced the gasket. it does work for a little while but not for long.

any ideas where to get one ?

also any ideas on the heater ?

thanks.

[Dazzler]

Sounds like the heater matrix needs flushing out, if the hose in is hot but the outlet is only warm then this would suggest and blocked matrix.
HTH.

[iangts]

Sounds like the heater matrix needs flushing out, if the hose in is hot but the outlet is only warm then this would suggest and blocked matrix.
HTH.

Yes that what i thought but i have flushed it out twice and still no diffrence or very little diffrence

anyone know how to take the heater matrix out ?

[Dazzler]

Did you back flush as well??
Does the water flow equally well in both directions??

[TheBoy]

If it has A/C, check the HBV is working properly as well

[iangts]

Did you back flush as well??
Does the water flow equally well in both directions??

Hi " Back Flush " ?
Water did not flow well at all into the heater matrix pipes, i boughts some wynns coolant flushed and used that but struggled to get it into the heater matrix as took forever to get into.

can i get it into the heater matrix any other way ?

Thanks.