Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: 2.2 Cam position sensor fitting?  (Read 638 times)

0 Members and 1 Guest are viewing this topic.

Geoff-H

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 14
    • View Profile
2.2 Cam position sensor fitting?
« on: 30 March 2008, 21:58:54 »
As a consequence of my last posting, I went out and bought a replacement camshaft position sensor for my 2.2L petrol Omega (nasty pain in the wallat!) and then looked at the Haynes manual for how to fit it. The book says it has such a sensor but that is it! (no real surprises there damnit!)

Can someone give me a few clues as to how to fit the new sensor and whether there are any pitfalls to avoid?

Many Thanks

Geoff    :-/
Logged

markey mark

  • Omega Baron
  • *****
  • Offline Offline
  • Gender: Male
  • SLady bitshorpe north lincs
  • Posts: 4236
  • banned for repeatedly reneaging on deals.
    • View Profile
Re: 2.2 Cam position sensor fitting?
« Reply #1 on: 30 March 2008, 22:01:28 »
you have to remove cambelt cover and look between to two pulleys there is a small e8 bolt take that out and wiggle it up from coil pack cover and away you go ! refitting is reverse of removel !! :y :y
Logged

Geoff-H

  • Newbie
  • *
  • Offline Offline
  • 0
  • Posts: 14
    • View Profile
Re: 2.2 Cam position sensor fitting?
« Reply #2 on: 31 March 2008, 15:03:34 »
Thanks Mark  :y :)
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.017 seconds with 20 queries.