Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Please check the Forum Guidelines at the top of the Newbie section

Pages: [1]   Go Down

Author Topic: Plenum to Air Intake Torque Values  (Read 782 times)

0 Members and 1 Guest are viewing this topic.

subliminal

  • Guest
Plenum to Air Intake Torque Values
« on: 05 May 2008, 15:13:59 »
Does anyone know what the correct torque value is for the four screws securing the plenum to air intake on a V6? Referring to http://www.omegaowners.com/forum/YaBB.pl?num=1156365122 and "Intake bridge to intake flange", should it be 20 Nm?

(Oh, and while we're at it, generally speaking, how 'tight' shoudl I be tightening the jubilee clips around pipes? I know generally that varies rather a lot depending on the size and type (plastic, rubber, etc.), but any guidlines?)
« Last Edit: 05 May 2008, 15:35:03 by subliminal »
Logged

TheBoy

  • Administrator
  • *****
  • Offline Offline
  • Gender: Male
  • Brackley, Northants
  • Posts: 107026
  • I Like Lockdown
    • Whatever Starts
    • View Profile
Re: Plenum to Air Intake Torque Values
« Reply #1 on: 05 May 2008, 16:50:51 »
8nm
Logged
Grumpy old man

subliminal

  • Guest
Re: Plenum to Air Intake Torque Values
« Reply #2 on: 05 May 2008, 17:00:18 »
ta muchly!
Logged

Martin_1962

  • Guest
Re: Plenum to Air Intake Torque Values
« Reply #3 on: 05 May 2008, 21:16:32 »
I use windy handle tight, not using a rachet handle
Logged
Pages: [1]   Go Up
« previous next »
 

Page created in 0.009 seconds with 17 queries.