Ljay's 3.0 MV6 Manual....
Idle is fairly good, stays within 10rpm of 700 (does now after IAC clean anyway)
However there is a fair shudder, and a smell of petrol
Plugs were changed under a year ago, no evidence of a misfire.
Both manifold gaskets have been changed, however the passenger side is only held on with one stud, although there is no ticking when cold.
Here is the live data....
Measuring blocks information:
Identifier 1D
Battery Voltage 13.5 V
Immobiliser Signal Received
Immobiliser Active
TPS Signal (Throttle Position Sensor) 0.45 V
Simulated Idle Position Active
Simulated Full Load Switch Inactive
Mass Air Flow Sensor 0.71 V
Mass Air Flow Sensor 11 kg/h
Coolant Temperature 0.97 V
Coolant Temperature 91 °C
Intake Air Temperature 2.73 V
Intake Air Temperature 39 °C
Engine Type 6 Cylinder
Transmission Coding Manual Transmission
Park/Neutral Switch P - N 0V
A/C Information Switch (Air Conditioning) Active 12V
A/C Compressor Switch (Air Conditioning) Inactive 0V
Telltale (Check Light) Off 12V
Fuel Pump Relay Active 0V
Spark Angle before TDC (Top Dead Centre) 10 °CA
Ignition Coil Cyl. 1+4 (Cylinder) Load
Ignition Coil Cyl. 2+5 Spark
Ignition Coil Cyl. 3+6 (Cylinder) Load
Knock Signal Inactive
Knock Retard 0 °CA
Secondary Air Pump Relay Inactive 12V
EGR Valve (Exhaust-Gas Recirculation) Inactive
EGR Position Feedback (Exhaust Gas Recirculation) 0.76 V
Fuel Tank Ventilation Valve 0%
O2 Sensor 1 215 mV
O2 Sensor 2 146 mV
O2 Sensor Loop 1 Closed
O2 Sensor Loop 2 Closed
Air/Fuel Ratio 1 Lean
Air/Fuel Ratio 2 Lean
O2-Loop 1 Integrator 144 Steps
O2-Loop 2 Integrator 137
O2-Loop 1 BLM Idle (Block Learn Map) 219 Steps
O2-Loop 2 BLM Idle (Block Learn Map) 189 Steps
O2-Loop 1 BLM Partial Load (Block Learn Map) 130 Steps
O2-Loop 2 BLM Partial Load(Block Learn Map) 121 Steps
Hall Sensor Inactive
Engine Speed Pulse Active
Engine Speed 693 RPM
Idle Air Control 149 Steps
IAC Integrator (Idle Air Control) 122 Steps
IAC Adaptation Slope (Idle Air Control) 152 Steps
IAC Block Learn (Idle Air Control) 124 Steps
Desired Idle Air 10 kg/h
Actual Value Idle Air 10 kg/h
Desired Engine Idle Speed 700 RPM
Injection Pulse 3.3 ms
Engine Load Signal 0.9 ms
TPS Load Signal (Throttle Position Sensor) 0%
Vehicle Speed Pulse Not Received 12V
Vehicle Speed 0 km/h
Intake Manifold Valve 1 Inactive 12V
Intake Manifold Valve 2 Inactive 12V
Torque Control Inactive
A/C Cutoff Relay (Air Conditioning) Active 0V
Diagnostic Request Inactive 5V
Ill post the same from mine for comparison as well....