Topic: Where's the best place to fit the LPG ECU ? (Read 1105 times)

Ken T · « **on:** 03 November 2009, 20:43:57 »

I am hoping to progress my LPG installation, if the weather dries up a bit. Any recomendations as to where to fit the various bits ?. It looks as if the favourite for the injectors is on top of the valve covers, and there is a fair bit of real estate below the expansion tank which might suit the evaporator and shut off solenoid, but where to fit the ECU ?.

Ken

Kevin Wood · « **Reply #1 on:** 03 November 2009, 21:03:02 »

Mine went under the air filter where the levelling pump is on models with wallow-o-matic suspension.

Failing that they can be squeezed in under the scuttle by the cabin filter.

Kevin

Ken T · « **Reply #2 on:** 03 November 2009, 21:13:30 »

Thanks Kevin, yes that looked possible, but I wanted to see what others had done. There is a lot more space round the 4 pot engine.

Ken

feeutfo · « **Reply #3 on:** 03 November 2009, 21:30:43 »

mine, as Kevins and others is under the air filter, in the front wing as said. Those that cant afford a levelling system will have an easier life fitting it there.

Free space within range that the loom allows is a little limited. From memory mine would not reach the scuttle area. Have since i had a thought to mount it next to the vapourisor along the wing as you mentioned. But never got round to seeing if it will actually fit there....? Would be a bit drier. Also should be mounted with the plug at the bottom so any water does not run down the loom and into the plug. The ECU has a water tight seal but nout wrong with belt and braces. :-)

megaomega123 · « **Reply #4 on:** 03 November 2009, 21:39:57 »

Mine is in the scuttle but I would advise against there. I have no pollen filter and the loom is semi crushed where it enters the scuttle.

Ken T · « **Reply #5 on:** 03 November 2009, 23:00:22 »

Thanks guys, I will have a look tomorrow and see. I'll post pics when finished.

( now if I superglued the lot, pipe run inc, on the roof there's a lot more space and no exhaust to get past

)

Ken

Lazydocker · « **Reply #6 on:** 03 November 2009, 23:39:34 »

There's plenty of space to squeeze it in next to the Self Levelling Pump if the loom is long enough.

TBH, I would think there are better places with a 4 pot as the engine bay has a fair bit more space

News:

Author Topic: Where's the best place to fit the LPG ECU ? (Read 1105 times)

Ken T

Where's the best place to fit the LPG ECU ?

Kevin Wood

Re: Where's the best place to fit the LPG ECU ?

Ken T

Re: Where's the best place to fit the LPG ECU ?

feeutfo

Re: Where's the best place to fit the LPG ECU ?

megaomega123

Re: Where's the best place to fit the LPG ECU ?

Ken T

Re: Where's the best place to fit the LPG ECU ?

Lazydocker

Re: Where's the best place to fit the LPG ECU ?