Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[skyblue]

This might be a stupied question but please bare with me for a mo.

I have been following the guide on changeing the cam covers on a V6 (replaceing mine  again) and have noticed that this tray cant be seen over the passenger side cam cover itself.... is there a way of disconecting it  so it can be moved out of the way while im refitting the cam cover ( as mine at the mo is right in the way )

[Jinglemaster2]

You can disconnect it, but I always found the easiest thing is to ease the loom out of the cable ducting, and remove the plastic ducting completely. This leaves a lot more room to see and get the P/S cover removed and replaced.

[skyblue]

You can disconnect it, but I always found the easiest thing is to ease the loom out of the cable ducting, and remove the plastic ducting completely. This leaves a lot more room to see and get the P/S cover removed and replaced.

Thanks for ya reply ..... where can I disconnect it  from  ? as I noticed there is a plug at the back of the engine  compartment but the other wire disappears into the depths of the unknown  :-? :-/

[Elite Pete]

There are little tags along the top, so have to undo them with a thin screwdriver and the lid will come off

[tidla]

use cable ties to lift it toward the bonnet and keep it there.

[skyblue]

Thanks again for the advice.... this could save me a packet  in donations to the  sweartin