Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[mark.adams]

Ok, got new heater matrix, next weekends plan is to fit it, i understand theres cutting of dash required, anybody fancy giving me some moral support, theres bacon rolls and tea in it for anyone....

[V6 CDX-er]

Bit far away for me

However, if you want me to grimace, suck air through my teeth and say "ohh, that'll cost you" from the other end of the internet, then just let me know.

[Lizzie_Zoom]

Best of luck!

When replacing that on a Carlton in the past I found it a straight forward job, although a lengthy one as I had to strip the whole dash / facia assembly out back to the bulkhead.  Very interesting to do, but I thought at the time I wish I could avoid it all!!

But, I know some on the OOF have perfected a great, relatively simple method of extracting and replacing the matrix on Omega's without stripping the facia out

Perhaps they can give you some guidence on here? :-/ :-/

I have found these pictures that were shown on the OOF at the time of a member doing the matrix using the shortcut method by cutting a very small section of the lower facia.  Hope they help:





 

[mark.adams]

Nice one thanks Lizzie, i'll keep you all updated when i start

[Lizzie_Zoom]

Ah, this thread Mark has now reappeared that I think will help you more than the two pictures I showed:

http://www.omegaowners.com/forum/YaBB.pl?num=1262554909