No extra wiring is required, just a modification of a couple of wires under the seat - all quite obvious if you look at the wiring diagram.
I dont think anyone is getting me....
I'm not stupid....I know how its supposed to be wired up.
That is NOT the issue!!
The issue is a non-working seat.
I have checked that the live feed is i'm using is working...and it is!
I am now going to have to check the seat bit by bit to see if there is a loose connection or a chaffed wire or something that i have missed.
I may run some lives to motors directly to see if they activate.
Never seen a total failure, only individual motor failure, hence suspecting a wiring fault.
Not sure which diagram you followed, but it needs multiple 12v and multiple grounds applied...
LOL....
I'm not sure how many times i can say it....
I am aware of the necessary Wiring.
I bought them off Darth Loo Knee and he has shown me how to wire them....as well as the above Link in the second post...I will add pictures of my wiring if it will help. But I a 99% sure that it is correct and it is soldered and secure.
It may well be the switch pack.
As there is no response at all regardless of how it is wired up.
The Main live is definitely active as it was used for the up/down of my old seat.
I have 3 wires connected to the Main live from the Elite Loom.
2 Wires connected to the Neg (-), as shown in the diagrams and examples pictures I have seen.