Topic: exhaust manifolds (Read 1465 times)

djhorner · « **on:** 25 February 2013, 21:43:46 »

will the 3.2 manifolds fit a 3.0 x30xe looking to upgrade

Lazydocker · « **Reply #1 on:** 25 February 2013, 21:49:16 »

Yes but will need a little modification IIRC $:-\$

Murph · « **Reply #2 on:** 25 February 2013, 21:51:24 »

What mods are needed?
I just bought a set for my 2.5. $:-\$

Marks DTM Calib · « **Reply #3 on:** 25 February 2013, 21:53:04 »

You need to trim the lip off the top of the front pipes (about 5mm)

Murph · « **Reply #4 on:** 25 February 2013, 22:05:13 »

Oh OK no problems there.

I'll have a look at the manifolds tomorrow to make sure I understand where exactly they need trimming.

serek · « **Reply #5 on:** 25 February 2013, 23:28:44 »

Oh OK no problems there.

I'll have a look at the manifolds tomorrow to make sure I understand where exactly they need trimming.

its not possible to trim them in wrong place

Murph · « **Reply #6 on:** 25 February 2013, 23:58:30 »

Oh good then even a simpleton like me can get it done then!

biggriffin · « **Reply #7 on:** 26 February 2013, 12:13:54 »

if somebody had some photos of were to trim that might help the op,and others who might wish to do the mod.

Marks DTM Calib · « **Reply #8 on:** 26 February 2013, 12:23:42 »

Think Jimbob took some pics of his

Jimbob · « **Reply #9 on:** 26 February 2013, 14:49:51 »

Think Jimbob took some pics of his

Murph · « **Reply #10 on:** 26 February 2013, 17:52:26 »

Thanks, that makes it clear.