Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[chrisgixer]

Plus if being pedantic to that level, arguably the red tab will get damaged slightly on removal. Just make people aware.

[05omegav6]

You don't need to remove the tab... You can also remove the door card and unscrew the pin... But why complicate things

[chrisgixer]

You don't need to remove the tab... You can also remove the door card and unscrew the pin... But why complicate things

Because.... The red tab will get damaged.

[05omegav6]

  I guess then the real question is which would be more annoying...

[chrisgixer]

Depends if the owner can wait until the door card needs to come off.


...then replace the door motor, as the guide, and completely forget about the rattling poxy door pin

[steve6367]

Plus if being pedantic to that level, arguably the red tab will get damaged slightly on removal. Just make people aware.

I managed to keep mine completely unmarked - which is unusual!

[chrisgixer]

What did you use? I find a knife gives best odds.

[EMD]

What did you use? I find a knife gives best odds.

That was going to be my next question  I used a stanley blade .. seems its not that though .

The passenger seat is rattling when no one sits in it 

[05omegav6]

What did you use? I find a knife gives best odds.

That was going to be my next question  I used a stanley blade .. seems its not that though .

The passenger seat is rattling when no one sits in it 

Check the two screws under the rear pocket panel and that the four seat bolts are secure

[EMD]

What did you use? I find a knife gives best odds.

That was going to be my next question  I used a stanley blade .. seems its not that though .

The passenger seat is rattling when no one sits in it 

Check the two screws under the rear pocket panel and that the four seat bolts are secure

Ok , will get there in the end  Ill here a pin drop when the rear wheel bearing is fixed tomorrow 

[steve6367]

What did you use? I find a knife gives best odds.

A very fine screwdriver and changed up once I had an edge 

[Mr.OmegaMan]

Don't get me started on rattles an squeaks 

Have had all kinds on the FL Elite while most are now cured a few remain here's a few over the years I've found.... Centre air vents, rear seat belts, arm rest, steering column, drivers air vent/housing, transmission handle/sports mode button, glovebox, creaking rubber when windy passenger drivers door area, cd multi-changer metal plate something there rattles and it's not the plastic 4-stack holder, ummm that's about it  ... Saying that I'm ultra fussy about rattles so I'm told anyway 

[EMD]

Don't get me started on rattles an squeaks 

Have had all kinds on the FL Elite while most are now cured a few remain here's a few over the years I've found.... Centre air vents, rear seat belts, arm rest, steering column, drivers air vent/housing, transmission handle/sports mode button, glovebox, creaking rubber when windy passenger drivers door area, cd multi-changer metal plate something there rattles and it's not the plastic 4-stack holder, ummm that's about it  ... Saying that I'm ultra fussy about rattles so I'm told anyway 

Too many screws holding the elite together you see 

[steve6367]

Don't get me started on rattles an squeaks 

Have had all kinds on the FL Elite while most are now cured a few remain here's a few over the years I've found.... Centre air vents, rear seat belts, arm rest, steering column, drivers air vent/housing, transmission handle/sports mode button, glovebox, creaking rubber when windy passenger drivers door area, cd multi-changer metal plate something there rattles and it's not the plastic 4-stack holder, ummm that's about it  ... Saying that I'm ultra fussy about rattles so I'm told anyway 

How did you stop the transmission handle?

[05omegav6]

You can't really as the rattle is likely the selector release cable

This runs through the handle shaft...