Well, the snow stopped for an hour or two, so I braved the cold and tore into the pup-mobile`s engine bay looking for the coolant leak.
Got, the radiator out (eventually).....`lots of dismantling to get there though; such a fiddly job with the intake ducts and myriad hoses and wires....my hands are torn to bits!

I found the 'top hose' to be burst, underneath, just where it enters the block.....and completely out of sight (of course), not to mention the fact that the hose seemed to be 'welded' to the block spigot: eventually`had to cut it off, what a pig!:'(........I`ve pulled the rad out too, to inspect it, as I couldn`t see if that was damaged/leaking with it in situ....as you may see in the pics, I`ve grazed the 'fins' a little getting the fan assembly out, but the rad`s tubes seem ok.
Next step......
Clearly new hose/clips & coolant: but will the radiator 'pass-muster' after my slight heavy handedness in removal?.....how likely is the head gasket to have suffered?....after the leak became apparent, I drove only 70 yards up my driveway (at slow speed), turned and quickly reversed close to the barn and shut off the engine ASAP.



