good luck m8
it will mostlikly the ECU , I have had same troble this week iv got the caved up finggers and brused knuckels to prove it.
just waiting for the corurer from BBA reman to pick it up
For the help of others trying to get one out I found a bit of an easyer way
than in guide
if theres a couple of you
follow the guide as normal bat, fuse box, wiring, top coolent hose and pas resvour removed
now undo the two nuts eather side of the abs hydrolic unit
theres a plate over the one on the enging side, bend that back a bit to clear bolt
watch you dont lose the bolts/ studs the just push in the side of the unit in rubber bungs
now you can lift the whole abs pump up with ECU still attached
just unclip the 3 break lines from the plastic clip on bulkhead
now you can lift the whole unit the pipes are quit flexable
the flex a lot more than you would think with out damage
but dont go to mad bending them
now one of you can lift pump and other one can undo bolts
and it comes out far easyer doing like this.
and even more inportaintly it will be easyer to refit the 6 t20 bolts this way
as I was able to basicly life pump up enoutgh for you to unscrew all six bolts with ease.