Omega Owners Forum

Please login or register.

Login with username, password and session length
Advanced search  

News:

Welcome to OOF

Pages: [1]   Go Down

Author Topic: crankshaft sensor removal 2ltr 16v no AIR con  (Read 579 times)

0 Members and 1 Guest are viewing this topic.

OGCDaz

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • ashford kent
  • Posts: 11
    • View Profile
crankshaft sensor removal 2ltr 16v no AIR con
« on: 28 March 2010, 22:21:59 »
How do i remove it not very gd with cars  :'( :'(
Error Code P0335 Crankshaft sensor error
Logged

Darth Loo-knee

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Death Star
  • Posts: 18826
  • Jammie smells of Pooh....
    • TIE Fighter
    • View Profile
Re: crankshaft sensor removal 2ltr 16v no AIR con
« Reply #1 on: 28 March 2010, 22:27:44 »
Should be easy enough without the aircon pump there mate.
It is around where the dipstick goes into the block (on the passenger side) one bolt hold the Crank Sensor in place think its an E10 (torx socket) then just a matter of routing the cable in the same position and pulling it in  :y
Logged
Everything to do with Omega's. Breaking, Servicing from Cambelts to Oil Changes... Please Pm me for details...

OGCDaz

  • Newbie
  • *
  • Offline Offline
  • Gender: Male
  • ashford kent
  • Posts: 11
    • View Profile
Re: crankshaft sensor removal 2ltr 16v no AIR con
« Reply #2 on: 28 March 2010, 22:36:06 »
do i go underneath or above m8 ?
Logged

Darth Loo-knee

  • Omega Queen
  • *****
  • Offline Offline
  • Gender: Male
  • Death Star
  • Posts: 18826
  • Jammie smells of Pooh....
    • TIE Fighter
    • View Profile
Re: crankshaft sensor removal 2ltr 16v no AIR con
« Reply #3 on: 28 March 2010, 22:39:21 »
I personally would go from underneath to undo the torx bolt, then pull out the Crank Sensor. Then go from the top to pull it out and thread the new one whilst doing it so you know where it goes :y
Logged
Everything to do with Omega's. Breaking, Servicing from Cambelts to Oil Changes... Please Pm me for details...
Pages: [1]   Go Up
« previous next »
 

Page created in 0.011 seconds with 16 queries.