Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[RobG]

Fits a Calibra front
http://www.vauxhall-car-parts.co.uk/acatalog/copy_of_copy_of_copy_of_copy_of_copy_of_Bearings.html

[Gaffers]

F.A.G = Film Actors Guild?

My talent is wasted here......

[RobG]

F.A.G = Film Actors Guild?

My talent is wasted here......

Bugger off then

[henryd]

Your wrong Chris, the race you consider to be part of the hub isnt, its an insert and can be removed.

AndyC.....can you please confirm what part number 90510542 is 

I know I could get that race out in about 30 mins tops.

Mark,do you reckon its two separate bearings or one one double bearing?

[Marks DTM Calib]

Your wrong Chris, the race you consider to be part of the hub isnt, its an insert and can be removed.

AndyC.....can you please confirm what part number 90510542 is 

I know I could get that race out in about 30 mins tops.

Mark,do you reckon its two separate bearings or one one double bearing?

There a double race ball bearing made of a single outer race, two sets of balls and twin inner races.

I took one apart 4+ years ago when we did one of TB's and hence how I know you can remove the item in question (I run a bead of weld around the inside and they then pretty much fall out)

[Andy B]

.....
(I run a bead of weld around the inside and they then pretty much fall out)

Sir ......... I thank you 

Chris ..................... 

[Marks DTM Calib]

.....
(I run a bead of weld around the inside and they then pretty much fall out)

Sir ......... I thank you 

Chris ..................... 

Its simples Andy 

[Gaffers]

F.A.G = Film Actors Guild?

My talent is wasted here......

Bugger off then

Haven't you got a sister you need to shag?

[Andy B]

.....
(I run a bead of weld around the inside and they then pretty much fall out)

Sir ......... I thank you 

Chris ..................... 

Its simples Andy 

.......
Take it to somewhere that can run a good bead of weld along the outer (Kev's inner ) ie where the bearing race runs, and watch it fall out. 

It is indeed. 

[feeutfo]

Your wrong Chris, the race you consider to be part of the hub isnt, its an insert and can be removed.

AndyC.....can you please confirm what part number 90510542 is 

I know I could get that race out in about 30 mins tops.

I asked you at Newent how the race came out and you said you didn't know. 

Right, if you say so, disc cutter time? Or is the disc going the shatter?

[feeutfo]

Is this piece deep enough to show this none existent baring shell ?

[TheBoy]

chrisgixer, hard to tell from pics, but where blue arrow is, is that a 'join'

[05omegav6]

Surely then the bearing shell between the 2 cuts should simply fall off only gravity holding it in place

Unless it's part of the casting...

[Andy B]

Surely then the bearing shell between the 2 cuts should simply fall off only gravity holding it in place

Unless it's part of the casting...

the cut on the right isn't deep enough, I'm not even sure the cut on the left is quite deep enough either 

[feeutfo]

Surely then the bearing shell between the 2 cuts should simply fall off only gravity holding it in place

Unless it's part of the casting...

Exactly as Al says. If that is join marked by TB, why hasn't the shell/race fallen away from the part removed?


Unless its part of the casting/hub?