Print

Please login or register.
1 Hour 1 Day 1 Week 1 Month Forever
Login with username, password and session length

[ffcgary1]

[][/img]
[][/][/img]
[][/img]
[][/img]

[ffcgary1]

Sorry they are a bit large, if somebody could resize for me that would be great but i guess you can see the basics of the install.

[ffcgary1]

[][/img]
LAST ONE HONEST

[ffcgary1]

Ok i have changed the magic filter after the vapouriser and found a gas leak on the small bore pipe from the filter that goes up to what looks like a small square box with an electrical plug. i fixed that by trimming back the pipe and fitting a new clip.
I have driven from feltham to mitcham a distance of about 20 miles and it performed fine with no hint of misfire or poor performance, when the new filter arrives from belguim i will change the one i cleaned with carb cleaner.
But i have noticed that the switch over from gas can be a little slow and requires a rev of the engine above 2,500 rpm to make it switch, even when cold or hot, is this a map issue if so that might be cured with a remap of the ecu.(Hopfully)
Gary.

[Lazydocker]

Sounds like a setting issue..  Used to do it on the old single point set ups... Switch over only above 2k RPM and even then it only switched when on over run

[ffcgary1]

I have done some research on the KME gold vap and it seems there is a temp sensor in the vap, but i cannot seam to find its location, it  has 2 wires to it but mine does not seem to have it, but i cannot see underneath the body of the vap. it might be there so will dig out a mirror and take a gander.
Could it be that at fault.

[doz]

It's smack bang in between the vaporiser pipes. 

[Lazydocker]

It's smack bang in between the vaporiser pipes.

Depends where the fitter put it But that's the obvious place and most likely

[doz]

em it's actually part of the Vap. on mine. Not moveable unless you want to start drilling holes. Or am i talking about the wrong part

[Lazydocker]

em it's actually part of the Vap. on mine. Not moveable unless you want to start drilling holes. Or am i talking about the wrong part

It screws in

[doz]

So where else can it be fitted? I'm confused?

[ffcgary1]

So am i cos i cant find it on mine

[Lazydocker]

So where else can it be fitted? I'm confused?

In any of the threaded holes by removing the bolt/set screw that is currently in it, exactly as will have been done to fit that one

So am i cos i cant find it on mine

Look for a 2 wire sensor either in the vaporiser or the coolant lines

[doz]

Which leaves me even more confused asI have temp sensor in the VAP and also in one of the VAP lines....... or is one for pressure? Or did I have another one fo................ ah fek it it works 

[Lazydocker]

Which leaves me even more confused asI have temp sensor in the VAP and also in one of the VAP lines....... or is one for pressure? Or did I have another one fo................ ah fek it it works 

The one in the vap is vap temp, the one in the vapour lines is combined gas temp and pressure