2.2 / 2.0 cambelt party - Brackley

[Markie]

I have a day pass so will be there to observe proceedings.....and do a few cambelts and rear brakes etc.....

and get sore knees  

[Marks DTM Calib]

Not with my new gel filled knee pads.....make you like a total arse though...

[Phil]

.....make you like a total arse though...

Who is a total arse and why would you like him if hes a total arse?  

[Admin]

I'll tootle down, I'll bring the estate to carry Marks tool box!  

[tunnie]

should add that its not just 2.2's.... the 2.0's can be done too  

[Taxi_Driver]

Can i bring my 2.2?......tho unless its just spanner passing etc i wont be much help  

Could tho go out on food run etc  

History of my cambelt.....Cambelt and tensioner done at 42k.....new water pump at 50kish (carnt quite remember   ) Tensioner done again a few k later.....its now approaching 86k....by my reckoning its a few k short yet of needing doing....but to be on the safe side.......

On thing that might stop me is.....im advertising my merc this week and i might get someone wanting to view it on Sat  :-/

[Auto Addict]

Can i bring my 2.2?......tho unless its just spanner passing etc i wont be much help  

Could tho go out on food run etc  

History of my cambelt.....Cambelt and tensioner done at 42k.....new water pump at 50kish (carnt quite remember   ) Tensioner done again a few k later.....its now approaching 86k....by my reckoning its a few k short yet of needing doing....but to be on the safe side.......

On thing that might stop me is.....im advertising my merc this week and i might get someone wanting to view it on Sat  :-/

Excuses, excuses, excuses......

[Taxi_Driver]

Can i bring my 2.2?......tho unless its just spanner passing etc i wont be much help  

Could tho go out on food run etc  

History of my cambelt.....Cambelt and tensioner done at 42k.....new water pump at 50kish (carnt quite remember   ) Tensioner done again a few k later.....its now approaching 86k....by my reckoning its a few k short yet of needing doing....but to be on the safe side.......

On thing that might stop me is.....im advertising my merc this week and i might get someone wanting to view it on Sat  :-/

Excuses, excuses, excuses......

If you bought it for Mrs AA, AA then i wouldnt have an excuse   ....i'll except a packet of smarties for it.......












.......plus £3999  

[TheBoy]

Can i bring my 2.2?......tho unless its just spanner passing etc i wont be much help  

Could tho go out on food run etc  

History of my cambelt.....Cambelt and tensioner done at 42k.....new water pump at 50kish (carnt quite remember   ) Tensioner done again a few k later.....its now approaching 86k....by my reckoning its a few k short yet of needing doing....but to be on the safe side.......

On thing that might stop me is.....im advertising my merc this week and i might get someone wanting to view it on Sat  :-/

Remember TD, 40k/4yrs is the MAXIMUM.  I try to get mine in that little bit earlier, at a time that is convenient to me, rather than worrying and rushing to get done at last minute.

[Auto Addict]

Can i bring my 2.2?......tho unless its just spanner passing etc i wont be much help  

Could tho go out on food run etc  

History of my cambelt.....Cambelt and tensioner done at 42k.....new water pump at 50kish (carnt quite remember   ) Tensioner done again a few k later.....its now approaching 86k....by my reckoning its a few k short yet of needing doing....but to be on the safe side.......

On thing that might stop me is.....im advertising my merc this week and i might get someone wanting to view it on Sat  :-/

Excuses, excuses, excuses......

If you bought it for Mrs AA, AA then i wouldnt have an excuse   ....i'll except a packet of smarties for it.......












.......plus £3999  

Mrs AA says, keep the Merc, she'll buy you a packet of smarties....

[Taxi_Driver]

Can i bring my 2.2?......tho unless its just spanner passing etc i wont be much help  

Could tho go out on food run etc  

History of my cambelt.....Cambelt and tensioner done at 42k.....new water pump at 50kish (carnt quite remember   ) Tensioner done again a few k later.....its now approaching 86k....by my reckoning its a few k short yet of needing doing....but to be on the safe side.......

On thing that might stop me is.....im advertising my merc this week and i might get someone wanting to view it on Sat  :-/

Remember TD, 40k/4yrs is the MAXIMUM.  I try to get mine in that little bit earlier, at a time that is convenient to me, rather than worrying and rushing to get done at last minute.

Good point TB  

If Tunnie says ok......i'll be along.....any merc viewers will have to come on Sunday  

[tunnie]

Can i bring my 2.2?......tho unless its just spanner passing etc i wont be much help  

Could tho go out on food run etc  

History of my cambelt.....Cambelt and tensioner done at 42k.....new water pump at 50kish (carnt quite remember   ) Tensioner done again a few k later.....its now approaching 86k....by my reckoning its a few k short yet of needing doing....but to be on the safe side.......

On thing that might stop me is.....im advertising my merc this week and i might get someone wanting to view it on Sat  :-/

Remember TD, 40k/4yrs is the MAXIMUM.  I try to get mine in that little bit earlier, at a time that is convenient to me, rather than worrying and rushing to get done at last minute.

Good point TB  

If Tunnie says ok......i'll be along.....any merc viewers will have to come on Sunday  

Hey TD, your more than welcome to come down!   Once I have seen mine being done I should be able to get stuck into another, we will also have MarkDTM just down the road in case we hit trouble!

I have to agree with TheBoy on your cambelt, it should all be done at the same time. Looking at those numbers your actual belt has done 44k!!

Get on the phone to Autovaux and get them ordered, £101 for belt kit &, pump. £134 from Vaux direct.

I am getting my aux belt done too, at only £15 worth doing!

[Taxi_Driver]

Can i bring my 2.2?......tho unless its just spanner passing etc i wont be much help  

Could tho go out on food run etc  

History of my cambelt.....Cambelt and tensioner done at 42k.....new water pump at 50kish (carnt quite remember   ) Tensioner done again a few k later.....its now approaching 86k....by my reckoning its a few k short yet of needing doing....but to be on the safe side.......

On thing that might stop me is.....im advertising my merc this week and i might get someone wanting to view it on Sat  :-/

Remember TD, 40k/4yrs is the MAXIMUM.  I try to get mine in that little bit earlier, at a time that is convenient to me, rather than worrying and rushing to get done at last minute.

Good point TB  

If Tunnie says ok......i'll be along.....any merc viewers will have to come on Sunday  

Hey TD, your more than welcome to come down!   Once I have seen mine being done I should be able to get stuck into another, we will also have MarkDTM just down the road in case we hit trouble!

I have to agree with TheBoy on your cambelt, it should all be done at the same time. Looking at those numbers your actual belt has done 44k!!

Get on the phone to Autovaux and get them ordered, £101 for belt kit &, pump. £134 from Vaux direct.

I am getting my aux belt done too, at only £15 worth doing!

Cheers m8  

But if i was to believe lying vx dealer.....they change the belt and tensioner when they do any work on water pump....tensioner ...so it should be a few k shy of doing....but you could be right...its overdue....if they lied yet again to me   all that work was warranty so i have no actual proof...like reciepts  

[tunnie]

i would not be surprised if they re-used the same belt!

Its worth doing since your Omega is your job and need it for your business!  Its not worth risking the engine over £100

[Taxi_Driver]

I am getting my aux belt done too, at only £15 worth doing!

I just had to had veccyB aux belt done as it snapped it   .....thought easy job...cost me about £14 for belt.....was i ever wrong   .....ended up taking to my local garage.....you have to take off engine mounting to fit it   ....no wonder i couldnt work it out how to fit it