I wonder if Mrs TB has a tape measure, I could measure it.
But the Irmscher bumper does hang a lot lower than a std bumper (PFL or FL). Still, it needed respraying again anyway
They all (air dams) rub to a certain extent, so it is lower of course. Where as the standard one has a rubber strip. So by default you do have to be carefull. I know TB doesn't comprehend this concept, but common sense must prevail. Surely?
Address the glaringly obvious and correct the ride height.
I wonder if Al's rubs.. ? Knowing his car sits much higher.
Oh I give up
Is it sagging? Poorly fitted? The cross member could be raised on the bolt holes. And what does the ride height measure?
I don't believe so. She's gone out in it tonight, so can't measure.
I do just think the Irmscher bumper is low, and additionally, low further forward, with lowest point being right at the front. The OE bumper's lowest point is the rubber, and that's further back. If that makes sense?